What size of wrench do I need and procedure to remove all four seats out of a 2007 Dodge Nitro. I like to swap out the old ones for leather. Any help would be appreciated

Ebay !

I looked at info for the 3.7L engine, looks fairly straight forward. Take negative battery cable loose and isolate. Remove generator belt. Remove electrical connector from generator. Remove bolts from generator. Remove generator.
If your going to work on your own vehicle, you need a basic set of tools, wrenches and sockets, standard and metric sizes. I don't know the actual socket or wrench size.

well your gonna need a few special tools for this , im not sure your avg home mech would want to spend the money to buy them, (vac pump , charging hoses, referigerant, o-ring seal release tools) and etc. and thats just the itmes you need to make it work again, your gonna need the new condenser and some long-g-g socket extensions to reach the old one for removal

Hi Kathryn, I'm glad to help! CAUTION: If you have "ACTIVE HEADREST" you will want to unhook the negative battery cable. NOTE: You'll also need to take the back of the seat cover off and unplug the connector going to the active headrest. Then simply push the release button on the side of the headrest and pull it upward and out of the seat. "HOWEVER" If you do not have the active headrest, then simply push the release and pull upward out of the seat. Hope this helps and have an awesome day Kathryn.

Yes there is a special tool kit.

Audio System Upgrade Package 2007 Dodge Nitro 2003-2006 Jeep

This sight should help you.

1. Remove door trim and the trim bezel. - 6
2. Take off the fastener from around the door handle trim - 5,4
3. Now you nee to remove the cap and screw covers with a panel tool or a small screwdriver. 3,4
4. Turn out the screws off the door trim. 2,4
5. Remove the window switch and unhook the connector.
6. Remove the trim panel from the 4 way around the handle of the panel trim. 4
7. Now gently lift up on the door panel and out.
8. See diagrams for further help as well.
9. Hope this helps.

Regards, Tony

the socket size should be a 8mm

Easiest way would be to find the two largest wires and hook them up to a hot wire from the fuse panel. One would go to a good chassis ground, and the other to a switch you could reach easily, and then to the hot wire.

You can access the oil filter easily from underneath next to the front, driver-side wheel at the front of the engine. There is clear access to the filter there.

For more info on Dodge Nitro, visit the forum at
http://www.dodge-nitro.com/dodge-nitro/