SOURCE: Remove rear plastic bumper cover
please email me at [email protected] with any other info or questions if you have already gone to a body shop
SOURCE: replacing front bumper on 1999 buick regal
7/16th or 10mm Sheetmetal nuts All over Behind the Bumper Thak Bumper off first
SOURCE: Bumper cover removal
It is a little more complicated than that. There are two nuts below the headlight assemblies in the engine compartment. You will need to remove the battery and overflow bottle to get at the one on the passenger side. Remove the turn signals in the bumper, then there are 2 or 3 bolts holding a mounting bracket behind the each of the turn signals. There are a number of bolts with washer heads and reatiners on the underside of the bumper as the previous responder indicated.
SOURCE: how to replace the rear bumper cover on a Chrysler
1. Open liftgate. 2. Remove both taillight assemblies by removing 2 hex-head bolts located in the area revealed when the liftgate is opened. 3. Remove 4 plastic retainers on the very bottom of the bumper cover in the rear. 4. Remove 2 phillips head screws in the wheel well rear lip. 5. Remove 4 pop-up plastic retainers in liftgate area. Use two screw drivers to lift the head and then pull the entire retainer out. 6. Remove a hex-head bolt from each side in the area revealed when the taillight assembly was removed. 7. Bend the bumper cover outward on each side to clear the wheel well lip and remove the bumper. Have a blanket or carpet on the ground to protect the bumper. 8. Remove metal clips from tabs that connect the upper bumper cover to the lower bumper cover. 9. Drill out pop-rivets that connect upper bumper cover to lower bumper cover. 10. Push tabs out of slots to separate the upper and lower bumper covers. 11. Release tab locks on chrome trim pieces and remove from upper bumper cover. 12. Reverse this process to replace the bumper cover.
SOURCE: I need to remove the front bumper cover on a 2002
Open hood and look on top of headlamps. You see a piece that looks like it slides in behind the light.
Have removed two mounting srews. Disconnected plastic grill. The bottom of the head light is held in by snap clips. The bumper cover needs pulled out far enough in order for the assembly to clear and come out.
Instructions
Engage the emergency parking brake, to avoid causing the car to roll or
move when removing the bumper.
Release
the screws holding the wheel well liners in place with a screwdriver. This will
expose the screws holding the bumper bolts. • Release
the bolts holding the bumper in place, using a wrench, and have a friend
support it while it remains wired to the car.
Disconnect the wiring running to the bumper to separate the fog lights
from the car. Pull out the light fixtures from the bumper cover.
Remove the grill in the bumper cover, taking out the screws holding it
into the cover. This will allow you to separate the grill and the bumper cover.
Secure the grill and light fixtures into the new bumper cover, using the
hardware you removed from the old cover.
Reconnect the necessary wiring. Support the bumper cover in front of
your car or have your friend hold it in place again.
Secure the bumper cover using the retaining bolts you took out earlier.
Tighten the bolts to hold the bumper cover securely against the car.
Replace the wheel well liners with the screws you took out.
1,105 views
Usually answered in minutes!
×