Question about Hyundai Cars & Trucks

1 Answer

What is the freeplay in a duel mass flywheel in a Hyundai iload diesel 5 speed

Posted by Leigh hadden on


1 Answer

Russ Hill

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Hyundai Master
  • 4,057 Answers

0.05mm max\ new 0.02mm

Posted on May 20, 2018


5 Related Answers


  • 5 Answers


A company in Northern Ireland called Exact Engineering will convert your dual mass flywheel to single mass.
See their website on and email them on [email protected]

Posted on May 29, 2009



  • 5 Answers


There is a company in Northern Ireland called Exact Engineering that can convert your dual mass flywheel to single mass using a complex engineering process ending with a finely balanced guaranteed single mass product. They have a complete courir service.

You can see their website at and contact them at [email protected]

Posted on May 29, 2009


Alex Jarema

  • 404 Answers

SOURCE: im trying to take off the duel mass flywheel it

You can buy one in any DIY motor parts shop.

Posted on Sep 30, 2010

Nicolo Carlo Parazo

  • 2187 Answers

SOURCE: I replaced the clutch assy. in a 2003 santa fe 2wd

Check if there is air in the system. You need to bleed out the clutch. Inspect the pedal linkages for binding or anything out of the ordinary. If bleeding the clutch did not resolve the issue, you need to go back to the transmission and inspect the fork or pivot ball. It could be possible that the conversion kit did not match the model that you have. It is possible that bad seals causing debris may have caused the issue and it was just coincidence that after replacing the flywheel did this happen.

You may also need to replace transmission fluid.

Posted on May 12, 2011

Richard Church

  • 193 Answers

SOURCE: Put duel mass flywheel clutch making noise when you start up EG like something catching making cliken noise

Starter drive gear not fully disengaging?

Posted on Oct 16, 2015

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Is the 2018 Hyundai iLoad van's diesel engine prone to injector seal leakage that may in some cases cause turbo failures?

i dont think a fuel injector leak could cause damage to a turbo. The turbo pushes more air into the engine so it can burn more fuel with the added air. a fuel leak either inside or outside the motor shouldn't have any affect at all on the turbo. if the fuel isn't getting into the cylinder to burn then it wont create the gases from that cylinder to spin the turbo up to proper speed, but the engine would run really rough if it wasn't getting fuel in one cylinder, same as taking off a spark plug wire on a gas engine.

Oct 12, 2018 | Hyundai Cars & Trucks

1 Answer

Jaguar 2L diesel SE 2005 Xtype,knocking rattling noise when in idle when you rev noise goes.

it sounds like the duel mass flywheel has gone bad unless there is something fouling ie .exhaust so get the exhaust etc first cos a new flywheel/clutch is a EXPENSIVE JOB! GOOD LUCK

Aug 27, 2018 | Jaguar Cars & Trucks

1 Answer

Want to buy a new Hyundai iLoad but have been told will have problems with DPF (Diesel Particle Filter) system if doing short trips witch will be doing a lot of. Is this true?

it is not only for that make but for all units using that particular system
talk around with muffler shops , the service dealer and other accredited service centers to get a better understand of the system and then make a decision

Nov 17, 2017 | Hyundai Cars & Trucks

1 Answer

Hi guys I have d22 a 1991 navara 5 speed manual,diesel.its making a squeling noise when using clutch now just sometimes in wont go into 4th gear its like neutral,,,any ideas whats going on,,,cheers

the sound is maybe coming from the release bearing on its way out.
The gear selection issue can be the pressure plate.
i would check the clutch hydraulics first if thats okay.
next check transmission oil level and condition
if that checks out replace the clutch kit
being a diesel it will have a dual mass flywheel those cannot be reconditioned must be replace

Sep 06, 2016 | Nissan Navara Cars & Trucks

1 Answer

I have a renault scenic 05 1.5 dci when I put my foot down on the clutch it makes a really bad noise even when I'm parked up what could this be please and any Idea on repair cost thanks

sounds like the clutch release bearing is worn often part of the slave cylinder on most modern cars needs the gearbox removing to sort which will be about 5 hours labour worth checking and replacing the clutch at the same time as its bound to fail soon after if you have my luck also if it has a duel mass flywheel which again most modern diesels have that will need checking as well not a cheap job if it needs the lot

Sep 25, 2013 | Renault Cars & Trucks

1 Answer

Hyundai Iload diesel won't start, have replaced engine in van with changeover from wrecker & it turns over but doesn't fire up

run the scanner to reset the ECM and immobiliser
make sure that the cranking speed is fast
check for air in the system
check that the stop solenoid is connected

Nov 03, 2012 | Hyundai Cars & Trucks

1 Answer

I am having problems with my 85 vette L98 car will start for a few seconds than die. I have put in new pump , filter.pump relay.t.p.s. set at 05.4v new a,i,c..igm mod,, tach filter and yesterday it...

That is a possible cause alright. I would get a can of fast freeze spray from a motor parts factor. If its ok when cold but shuts off when hot its very likely.when the engine shuts off, spray the crank sensor and immediately start engine. If it starts and stays running its your crank sensor. Does it have a duel mass flywheel?? Some times if the crank sensor picks up off the flywheel and the duel mass is worn , it then runs out of sync with the cam shaft pick up sensor, which will cut the vehicle off. Just a shot in the dark? If you can drive vehicle when cold , check for vibrations whilst engine is cruising at steady speed. You will not feel vibrations under load. Keep us informed on how you get on.

Aug 20, 2012 | Cars & Trucks

2 Answers


no, it shouldnt have any looseness to it and dual mass flywheels are VERY expensive to replace, BUT yes it can be converted to a solid flywheel, check out part number MU1989 or part number 798, that should get you on the right path to curing your problems, i welded the two independantly turning discs of my dual mass flywheel together but i wouldnt recommend anyone doing that without the proper equipment to do so (i.e. precision lathes, cast iron welding rods, etc)

Mar 29, 2009 | 1996 Ford F350 Crew Cab

2 Answers


The best thing to do is to take it to a transmission shop and ask them. They will be able to tell you if it is bad. This is the cheapest way to find out if it is bad and you can ask them how to tell for future knowledge.

Mar 29, 2009 | 1996 Ford F350 Crew Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Brad Brown

Level 3 Expert

18563 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides