There is no power coming to the switch, but ther is power going to it,help!!!!!!
You have gound for motor to switch you can unplug the motor kill and it will run but need to look at the salfy swicths the one to seat may be it look at wiring from it to engaceblade also to clutch switch
SOURCE: 1988 Ford F-150 iginition problem
its goi to be your Solenoid Switch is bad i had the same problem with my truck
SOURCE: mower deck won't engage John Deere 170
sound like the lawn deck is in a jam bent blades or damaged pulleys
SOURCE: I have a question. If yor mower want turn over
Hello Lynn,
Sounds like you have a problem on the key controlled side, so:
1. Power from the battery to the key switch? 6V or 12V I would guess.
2. With the key in the "Start" position, have you got voltage to the thin wire/small terminal on the solenoid?
3. Do you have a good ground from the starter motor to the chassis?
If all the above checks out then the control circuit for the starter should all be working A-OK & when you turn the key to the "Start" position you should be getting a good, strong "Click" from the solenoid.
So - on the starter circuit:
1. The HD cable feeding the solenoid should always have battery voltage on it?
2. When you operate the key you should hear the solenoid "Click" and the voltage from the HD feed cable should now be connected to the other HD terminal on the solenoid (these are the two you are shorting out with your screw driver to get the motor to turn the engine over).
3. If the solenoid is "Clicking" when you operate the key & the voltage from the main supply cable is being passed to the second HD terminal, but the motor is not operating, then you need to check your ground cable.
Hopefully by now you will have found & fixed the problem :)
SOURCE: 1998 yahama big bear 350 electric start is inop.
Sounds like bad start switch or wiring from switch to solenoid.
SOURCE: John Deere LT133 not starting
This is a common problem. The saftey interlocks are most likely keeping the tractor from completing the starter circuit. See the attached diagrams for curcuiit.
If off tracter ther park brake set switch must be closed along with thwe PTO off switch closed.
Check seat saftey switch
Hope this helps?
2,624 views
Usually answered in minutes!
×