It's an easy job to do yourself. You will need two sockets, (i think they are 9mm and 10mm). You will need to remove the entire spoiler the light is mounted into.
Open the tailgate and remove the trim behind the 3rd brake light. This will give you access to the four bolts holding the spoiler to the tailgate. Close the tailgate and lift the spoiler free. Unclip the wires and lift the spoiler off the car. The whole light unit is held in with two bolts. Unbolt, drop it out and fit the new one. Before refitting the spoiler, reconnect the wires and test the brake light works. Bolt the spoiler back into place. Refit the inside trim. Job done.
SOURCE: 2002 V6 Jeep Liberty-Oil Pump Replacement
Yes you have to check your pressure with a mechanical gauge first. If the pressure reading is good replace the oil pressure sending unit. They are known to go bad, and oil pumps going bad is rare.
SOURCE: 2007 Hyundia Sonata Brake Lights
There was recall for the 2006 and 2007 Hyundai Sonata Brake Light Switch assembly. www.promanuals.net
SOURCE: replacing brake light above trunk on 2006 chrysler
This is quite a process....
Removal
1) Disconnect and isolate the negative battery cable.
2) Remove the rear shelf trim panel.
3) Disconnect the CHMSL electrical connector (1).
4) Remove the two mounting fasteners (3) to the CHMSL (2).
Installation is opposite of removal.
Rear shelf trim panel
Removal
1) Disconnect and isolate the battery negative cable.
2) Remover the right and left lower and upper C-pillar trim.
3) Remove the nut that secures the center rear seat belt lower anchor to the stud on the floor panel and feed the seat belt webbing back through the opening in the top of the rear shelf panel trim (2) to the retractor.
4) Remove the push-pin fastener (1) that secures the trim (2) to the rear shelf panel.
5) Slide the trim forward to disengage the S-clip that secures the underside of the trim to the to the center of the shelf panel.
6) Remove the trim from the rear shelf panel.
Installation
1) Position the trim (2) onto the rear shelf panel(3).
2) Slide the rear edge of the trim rearward to engage the lens bezel of the center high-mounted stop lamp and far enough to engage the S-clip that secures the underside of the trim to the center of the shelf panel.
3) Install the push-pin fastener (1) that secures the trim to the rear shelf panel.
4) Pull the center rear seat belt lower anchor and belt webbing from the retractor through the opening the the top of the rear shelf panel trim and back down to the stud on the floor panel.
5) Install and tighten the nut that secures the seat belt lower anchor to the stud on the floor panel. Tighten the nut to 34 N m (25 ft. lbs.).
6) Reinstall the right and left upper and lower C-pillar trim.
7) Connect the battery negative cable.
C-pillar trim removal
Seat removal
Hope this all gets it done for you........
164 views
Usually answered in minutes!
×