Speedo signal comes from the abs unit. if there is no problems from the abs unit. it would be the signal from the ecu to the speedo but if you have speedo wave the signal is being interrupted. i.e sunroof. windows and the signal goes around these before it gets to the the speedo. if the speedo does not move when you turn on ignition then the problem is at the dash end as no power to the speedo this could be the connection that the dash sits on.
SOURCE: 2010 mahindra scorpio: how do you program a 2nd alarm remote
You'll need to find the valet switch in your scorpio. It is in glove box, towards the top, near the metal clip in which the lid of Glove Box Locks.
You have to turn "ON" the ignition.
Press that button once.....Leave it
Press that button again and hold it
You'll hear a beep confirming remote programming mode
Now press lock button of each remote to be programmed one by one for atleast 2 seconds
You'll hear a small beep on each button press confirming successful remote registration
Now leave that button
and close all doors and check the remotes for programming
Testimonial: "Thank you it took me 30 sec. GOD Bless"
SOURCE: mahindra scorpio 2002 model crde engine oil coming
Hi
Turbo cars do drag some oily residue through the inlet system and, if the hose seals are worn, wil drip oil. This is all ok..just clean up the hoses and fit new seals. Make sure you always flush engine oil and use a new oil filter with the CORRECT engine oil.
If the airways are not correctly serviced, air mass meters, sensors, throttle body, egr will all get clogged up.
Regular service saves money.
Cheers
Roger
994 views
Usually answered in minutes!
×