Question about 2005 Nissan Altima
How do i get it off
SOURCE: 2005 Nissan Altima
HEY WHATS UP BRO this is what you have to do i just got brand new headlight replacements for my 05 nissan altima and it looks great by the way if you replace one you should just do both becasue it will look weird. anyways i have an hid kit as well but so. what you have to do is remove the bumper take all the plastic screw things off the top and on the botton underneith the bumber then you remove 2 screws on each side of the bumper they are located kinda in the dender well then you unscrew those then you can pretty much pull the bumper off there are 4 screws holding on each headlight 2 on top one on the side and one on the bottom front in order to remove the headlight you have to take off the bumper. hope this helps oh ya and buy buy the way you should get an hid kit the bulbe size for the altima is an h1 bulb and you need to get the single beam buld. get it at xenoneyes.com and the the 6000k. The 6000k look the best and is the brightest trust me you wont be let down they are brighter and last longer than the standard halogen bulb um also and like 5 times brighter. they are 129$ at xenoneyes.com thats the cheapest price that i have seen and they are a great value and good quality just dont touch the bulb. oh ya if you replace one headlight do both it looks much better. maybe try this web site to show you a little bit of how to do it
hope this helps my email is [email protected] let me know how it comes out
Posted on Sep 19, 2008
The oil filter is located behind the right (passenger) inner fender cover. It is right next to the crankshaft pulley at the bottom of the front of the engine facing toward the right front wheel. I do not have a picture at this time.
Hope this is helpful!
Nissan Scope Technician- 10+ years experience in Nissan dealership.
Posted on Nov 04, 2008
The first objective is to figure out which bulb you need. I had to replace the bulb for the largest light which was a Sylvania 3157. The next objective is to remove the dang plastic carpet holder/net clip. Recognize that it is a two part piece. Use a flathead screwdriver for leverage. Pry the cap off by levering the screwdriver in the slot on the holder. Then go behind the carpet and pinch the plastic pin still holding the holder in place. Next,pry off the while plastic pieces from the two bolt/nuts you'll need to remove (see manual). Remove the nuts and give the two screws a push from the inside so you can see how the whole light casing comes off. Pry it off from the outside. On the backside of the bulb holder, turn bulb base counterclockwise and gently remove. Pull bulb upward and replace. Do not touch glass on new bulb with your fingers (wear non-powdered rubber gloves). Make sure the bulb snaps in place. Follow these instructions in reverse. Smile, you just learned something new and saved yourself some easy money.
Posted on Jan 09, 2010
SOURCE: I have a 2005 Ford
If you dont have a key fob you could probably do it this way. Open the driver's door, get in the vehicle and close the door, open the driver's window and lock the door with the key. Then unlock the door manualy from inside the car this should trigger the antitheft alarm. Close the door and cycle the key to lock and unlock the door. This sometimes works
Posted on Jun 08, 2011
there is a chip inside your car key
some times gets damage or the car computer gets damage and no longer recognize your key chip
this causes the anti theft system to prevent the fuel injectors to open and the engine will not start because has no gas.
the security light stain on is your hint of what is going on.
I had the same problem on a 99 Nissan Maxima but i got the car running again what you need to do is replace the engine computer and then call a locksmith to reprogram your key to be recognize by the new computer i when to a lot of pain and suffer to get this solve.
before changing any thing make sure the plastic part of the key is not broken, if it is call your locksmith to make you a new one before changing any thing.
NOTE do not use a computer from a salvage yard unless you get to see the actual car it came from
if it came from a car than has the body in one piece do not buy it
its real hard to diagnose this problem and
chances are it came there because of the same problem you have.
if the car looks like it was in a crash the computer is more likely to be good.
but its always best to get it rebuild or brand new if you can.
after you change the computer call the locksmith to get you car key reprogram.
Do not use a computer from a 98 or 2000 because they will not work no mater what the salvage yard tells you they are to make money not to help you so it has to be 99 only.
Posted on Jan 03, 2012
Tips for a great answer:
Sep 12, 2018 | 2005 Nissan Altima
Mar 28, 2018 | Nissan Cars & Trucks
Nov 03, 2016 | 2005 Nissan Altima
Nov 03, 2016 | 2005 Nissan Altima
Aug 09, 2015 | 2005 Nissan Altima 2.5
Jan 27, 2013 | 2005 Nissan Altima 2.5
Jul 06, 2012 | 2005 Nissan Altima 2.5
Mar 07, 2011 | 2005 Nissan Altima
Oct 06, 2010 | 2005 Nissan Altima
939 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: