Question about Peugeot 206

1 Answer

Peugeot 206 engine vibrating, misfiring, erratic revs fault code p0563

Just bought car, serviced 10,000ks ago, was running good for a few days, then battery died I replaced it and now my dash cuts in and out and engine vibrates worse. Spark plugs all seem ok and fuses are good too.

Posted by Emz Laced on

Ad

1 Answer

Simon Atkinson

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Peugeot Master
  • 1,708 Answers

Did you get the car plugged into a diagnostic reader after the battery change?
Some newer car ECU's need to be reset to 'new battery' settings. Over time the system alters the battery charge rate as the battery gets older and weaker so a new battery will overcharge if not reset..
The error code, (P0563), reads as "system voltage high".
Get the car plugged into a good diagnostic system and that will allow you to correct the error code and battery settings.
The other symptoms may settle down once the error code is sorted out.

Posted on Apr 14, 2018

Ad

5 Related Answers

Anonymous

  • 1 Answer

SOURCE: Engine vibrates, shakes car at 1700 rpm, smooth at 2000 rpm

Something similar happened to my van, and it ended up being that I needed to replace a tie rod in one of my wheels. Hope this helps! I know this was posted awhile ago.

Posted on Dec 28, 2008

Ad
TLRogue

Craig Davies

  • 99 Answers

SOURCE: peugeot 206 2001 petrol intermitant fault with starter motor

If the starter motor is sticking, it can draw a large current. If there is power down to the starter motor while its not starting then the starter is faulty. You can test this with a multimeter or just a test bulb connected to the smaller of the two wires on the starter, while cranking.Check you have a good earth from the battery to the engine. If the bulb lights up but no engine cranking then its a faulty starter.

TL

Posted on Jan 24, 2009

Anonymous

  • 1 Answer

SOURCE: 2003 saab 95 Aero - stalled...can't get it started

Fixed it myself. I checked power and ground on fuel pump, then w/rubber mallet I banged the fuel tank and the fuel pump went on for a few seconds while someone cranked car, it started for arou 20 -30 seconds. This helped me diagn. the problem and I put in a new fuel assembly.\

Cfirms

Posted on Mar 25, 2009

Anonymous

  • 17 Answers

SOURCE: peugeot 206 1.4lx misfiring engine light flashing

Probably a defect lambdasonde or inlet pressure sensor (MAP sensor) it will show many different errors on the test readout ex: inlet manifold pressure, knock sensor, lambda value wrong, idle speed out of range, etc.
read out the faults,after delete the readout, then drive one day, read faults out again , compare the results, and change the components from test

Posted on Nov 05, 2009

emissionwiz

Marvin

  • 85239 Answers

SOURCE: 2001 ford taurus 3.0 v6 code p0306 misfire

Please go to this page for engine misfire causes.

Posted on Aug 08, 2012

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Seat Leon 1.9 TDI, not starting


Get rid of it, and buy an other bullock cart.

Feb 27, 2017 | Cars & Trucks

1 Answer

96 S 10 chevy blazer just died while i was driving battery is good aalternator is good cant find problem no lights nothing will come on a few days before my engine dies when i wud go to start the thin


Make the FixYa experience better for everyone by voting.

Hi,

The possibilities are too numerous to get into here.

Either take your vehicle to AutoZone for a FREE diagnostic scan or they'll loan you a scanner. This will enable you to pinpoint the problem(s) almost immediately.

All the best,

Ben

Nov 20, 2011 | Cars & Trucks

1 Answer

Battery light on followed by other lights then died


check the wire from alternator to the battery and make sure its not loose on alternator. happened to me a few years ago, forgot to tighten wire to alternator. car lights on dash came on and car quit while driving. just make sure you are getting at least 14 volts at battery while its running, good-day !

Oct 26, 2011 | 2006 Dodge Grand Caravan

1 Answer

27kmiles. Runs great. Engine cuts out.


i would lean towards replacing the ignition switch.

Apr 09, 2010 | 1999 Porsche Boxster

1 Answer

Got a low votage msg couple of weeks ago and replaced the battery. Got the same msg a few weeks later; went away for a couple of days and when I came back car would not start. Took it to Pep Boys to run...


If the battery is not recharging while the car is running, bad connection between alternator and battery. If it is dying while sitting, but charging while running, something is draining it. What? Who knows. It could be anything from a clock on the radio to an engine fan that doesn't stop. Look for anything electrical that is on when the car isn't. ANYTHING. Even the smallest light can pull more juice than you'd expect. Good luck.

Dec 05, 2009 | Cadillac Seville Cars & Trucks

1 Answer

My eclipse will start and then just die, like its gas is cut off


We just had this and it was a sensor called something like the CAM TIMING SENSOR - which gave the engine bad timing when it tried to get going. The car is great since we got it replaced - but it cost like $360 to get it all diagnosed and replaced.

Aug 06, 2009 | 2001 Mitsubishi Eclipse

2 Answers

1990 JEEP Cherokee that won't start even after a new battery


It sounds kind of like you have bad alternator. The alternator uses the engines power to recharge the battery. When you replaced the battery the car ran off battery power untill it died. If the car will run while hooked up to another car while being jump started then the problem is deffinetely the alternator..

Please give a good rating, it is very importat to us..

Aug 01, 2009 | 1990 Jeep Cherokee Limited

1 Answer

My car sometimes wont start and when it does it cuts out and dies


Put a voltmeter on battery. It should say something like 12 volts. Start motor and see if you have about 14.5 volts while running. If not your charging system has failed.

Jan 03, 2009 | 1994 Buick Regal Gran Sport

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

scj103

Level 2 Expert

104 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...