Question about Ford Thunderbird

Open Question

How do you remove the nameplate on front fender on a 2004 Thunderbird

Posted by Judy Arroyo on

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the front fender on a 2004 kia optima


Sorry here but iam only thick cockney --fender is this the wing or the bumper

Nov 04, 2014 | 2004 Kia Optima

1 Answer

How change front fender f150 2000


Fender -Front Removal
  1. Remove the radiator grille opening panel reinforcement (8A284).
  1. If equipped, remove the front wheel opening moulding.
    1. Remove the pin-type retainer.
    1. Remove the screws.
    1. Remove the wheel opening moulding.
    sy1~us~en~file=n12124a.gif~gen~ref.gif
  1. Remove the front fender splash shield (16103).
    1. Remove the screws.
    1. Remove the pin-type retainers.
    1. Remove the front fender splash shield.
    sy1~us~en~file=gn2615a.gif~gen~ref.gif
  1. Remove the cowl grille.
  1. On RH front fender, remove the antenna mast.
    sy1~us~en~file=k21762b.gif~gen~ref.gif
  1. On RH front fender, remove the antenna base.
    1. Remove the radio antenna base cap (18A927) by gently inserting a thin straight-edged screwdriver underneath the cap and carefully following inside the perimeter until both snaps are free.
    1. Remove the screws.
    1. Lift the antenna base.
    1. Disconnect the radio antenna lead-in cable (18812) and remove the antenna base.
    sy1~us~en~file=k22299b.gif~gen~ref.gif
  1. Remove the fender stuffer.
  1. Remove the stone guard.
    1. Remove the pin-type retainers.
    1. Remove the stone guard.
    sy1~us~en~file=gn2618a.gif~gen~ref.gif
  1. Remove the front fender.
    • Remove the bolts.

Sep 17, 2014 | 2000 Ford F150 Flareside SuperCab

1 Answer

How do you get acces to right fender on expedition to pound damage out?


you can take out the inter wheel well fender or guard I forgot what they call it. remove the tire and you can get to the bolts a lot easier. when you take out the inter fender you may be able to get to the dent from the fender wheel well. if not and you need to remove the fender you will find bolts under the hood along the top of the finder edge. there is one under the cow as well right close to where the fender connects to the suv by front door. you will also find bolts that hold it to the front bumper I believe. you might have to look around to see if there is more. I just replaced my fender on my 2003 expedition about a month ago. you can get them on line for about $75. also I just remembered there are like 3 bolts that you can get to right by the front door running down to the trim piece on the bottom of fender. good luck

May 27, 2014 | 2004 Ford Expedition

1 Answer

How do I replace the windshield washer resevoir on a 2004 Pontiac grand am?


Step 1:

Remove the drivers front wheel

Step 2:

remove the plastic inner fender well.

Step 3:

you will then see the washer reservoir. there will be one screw towards the front of the car thats behind the air tube that you will have to feel for in order to find/remove. The other two bolts are can be clearly seen with the fender well removed.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Dec 15, 2012 | 2004 Pontiac Grand Am

2 Answers

I NEED TO CHANGE MY DODGE STRATUS 2004 BATTERY . WHERE IS IT LOCATED


the battery is located in front of the drivers side front wheel behind the inner fender well.you will have to remove enough of the inner fender to gain access to the battery to replace it.

Jun 22, 2011 | Dodge Stratus Cars & Trucks

1 Answer

How do you change a front signal bulb on a 2004 accord


Front turn signal bulb replacement

1. Remove the inner fender
2. Disconnect the 3p connector from the front turn signal/side marker light.
3. Turn the bub socket ( 45 degree ), counterclockwise to remove the bulb.
4. Install a new bulb in the reverse order of removal.

Apr 12, 2010 | 2004 Honda Accord

1 Answer

I need a schematic to replace the PCM (Powertrain Control Module)in my 1994 Fodr thunderbird 3.8L V6 without/supercharger ..Is this is Big job for a backyard mechanic and how long should it take, my real...


  1. Easy job and should have no problems here some help
    Disconnect the negative battery cable.
  2. Detach the engine control sensor wiring connector from the ignition control module by pressing down on the locking tab where it is stamped PUSH, and remove the connector.
  3. Remove the ignition module and the module bracket from the front fender apron.
  4. Unfasten the two ignition module retaining screws, then remove the ignition module form the module bracket.

To install:


0900c1528006b5b4.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 2: The ignition module on 1994-95 vehicles is mounted on the front fender apron
  1. Install the ignition module onto the module bracket. Tighten the retaining screws to 24-33 inch lbs. (2.7-3.7 Nm).
  2. Position the ignition module and bracket assembly onto the front fender apron. Secure with the retaining bolt and tighten to 35-50 inch lbs. (4-5.6 Nm).
  3. Attach the engine control sensor wiring connector to the ignition module.
  4. Connect the negative battery cable.

Nov 19, 2009 | 1994 Ford Thunderbird

1 Answer

2004 thunderbird tail lamp burned out. How do I


Look in the trunk pull the cover or lining away so you can get at the bolts to remove lamp housing if bulb socket isn't in site

Sep 26, 2009 | 2004 Ford Thunderbird

1 Answer

My antenna on 1996 Thunderbird 2 door was broken off by some kids. It was a power antenna. I just want to listen to some music and stay cheap on the fix. Someone said I have to remove the fender over...


remove front right rear screws on splash shields. you should be able to remove it with out removing the fender. you can get one at the salvage yard.

Apr 11, 2009 | 1998 Volvo S70

1 Answer

Where is the fuel filter in an 04 t-bird


its behind the left front wheel well , you will be required to remove left front wheel , remove left front wheel well rear splash shield , now you will see it . cheers .

Jan 10, 2009 | 2004 Ford Thunderbird

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...