SOURCE: How do I replace a camshaft position sensor on a 2000 ford escort
bullshits, the CMP sensor is near the 4 injector, you have to take out all the electric conector near injector 4, take out the 2 screws that hold the fuel rail, sometimes you have to take out the 4 injector for the space, then take out the screws that hold the CMP, lub the o´ring of the new one and reverse this steps.
SOURCE: front wheel bearing
Service and Repair
SOURCE: belt diagram 2000 ford escort
Hi!
Please check this out---
Please rate this solution and ask for any clarifications if needed.
Thanks
Rylee
SOURCE: grinding noise in front wheel just changed pads not pads
sound like front wheel bearings badly worn.
SOURCE: how do I replace a 1998 ford escort front brakes
THIS IS FREE INFORMATION...FROM WF
Pads
Removal
1. Raise and support the vehicle.
Brake and clutch assemblies should be cleaned using a vacuum cleaner recommended for use with asbestos fibers such as brake/clutch/service vacuum. The bag must be labeled per osha instructions, sealed, and the trash hauler notified as to the bag's contents.
If a vacuum suitable for asbestos is not available, cleaning should be done wet. If dust generation is still possible, technicians should wear government-approved toxic dust purifying respirators.
2.Remove the wheel and tire assembly.
3.Remove the W-spring.
4.Remove the M-spring.
5.Remove the disc brake caliper locating pins (2B296).
6.Remove the front disc brake pads and shims from the disc brake caliper (2B120).
7.Compress the caliper piston completely into its BORE
NOTE: Apply a thin layer of Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A Motorcraft WA-10 or equivalent meeting Ford specification ESE-M1C171-A to both sides of the perforated shim only.
37 views
Usually answered in minutes!
×