When do they have carpet bowls at ormsby house

not sure here never seen one but am i to presume that the removed the primary sediment bowl filter ,if so then the washer is the seal in the top part against the bowl when its pushed up into the housing

• If you smoke in your car, then this will be obvious but even someone else smoking in the car unbeknown to you can leave a lingering odor. To try and get rid of it, place two towels into two separate plastic bowls and fill with white distilled vinegar. If the car is really big, use additional bowls. Place the plastic bowls into the car with the vinegar-soaked towels. One should sit near the ashtray, and the other one on the backseat. The vinegar will absorb the cigarette odors from the car, so that when you remove the bowls, the odor should leave too. If needed, repeat.[7]You can also try sprinkling baking soda and/or carpet deodorizer over the upholstery and carpet respectively, leave for a few hours, and then vacuum it up. If you or somebody else regularly smokes in the car though, the odor will always be present, so the best thing to do is to stop smoking in the car.

This is also documented in the owners manual. Open the trunk and remove the side-carpet retainer clips, these push-on, but need to be unscrewed to be removed. Once the clips have been removed, pull the side-carpet away, this will reveal the bolts holding the light housing. The nuts are 10mm, remove them and then push on the studs/bolts to push the light housing free. You can now access the light bulbs. Experience has shown that if one goes bad the others will follow shortly, so replace the bigger lamps and the smaller ones at the same time.

should be able the access the lights from inside the trunk. look for a panel on the backside of the light housing. you may have to pull back the carpet or remove a panel with a screw driver. light holder should twist out of the housing.

The flter housing airbox is accessable only from driver's side after accelerator pedal assembly is removed.
There are three screws that secure the housing. The carpet will also need to be pulled back slighty to remove the filter.

clogged condensate drain in the evaporator housing.

open trunk, pull down carpet around break lights you will see 3 or 4 wing nuts remove them pull out complete tail light section

open trunk,remove carpet , you will see bolts to light housing,remove nuts, light housing will seperate from body,replace bulb.

Ok, open trunk, there is carpet in there. Either the carpet is just sitting in there and held in by some plastic screws or nuts or the carpet is held in by the trim on the edge. If it's held in by the trim, remove trim either by removing screws that hold it in or if no screws they should pop right out. If the carpet is held in by screws/nuts those screws/nuts can either be on the outside the carpet or even under it if carpet is held in by the trim. There is at LEAST 3 screws/nuts holding light in. There could be 4. When all nuts are removed, you should be able to wiggle lamp housing out. If you can't, you can tap on those bolts sticking out to help get it started. If it still will not come, double check to make sure ALL screws/nuts are removed.