Question about Ford ZX2
SOURCE: 2001 Chevy Impala won't start
If the battery has gone dead, it could cause the security system to go into full lock-up mode. If it has locked up the accessories will work after the battery is charged back up , but the power to the starter will be cut off and it wont turn over. You need to do the 30 minute learn procedure. A GM dealer will print it out for you and you can do it yourself. It's very simple if you follow the procedure exact. hope this helps and good luck.
Posted on Mar 25, 2009
the battery says 12 volts but may be dropping to 4 or 5 under a load...i would suggest jumpstarting the car and see what happens.the battery should read in the high 12 volts and not less than 9.5 under cranking. the dash lights go out on your car when starting,and the alarm will go off ,and disable the ignition if the voltage is too low in cranking the car because the computer will shut it down and activate the anti theft.....check your battery posts are tight. best of luck
Posted on Jul 22, 2009
Your engine computer is bad. It's a good thing that you mentioned about the check engine light dying also, as this is a classic sign of a bad ecm. I have repaired more than one of these Jeep computers, replacing the three power capacitors located inside the computer, and they have worked for years afterwards. If you don't have the skills or knowledge to repair the ecm, get yourself a rebuilt ecm unit and swap it out.
Posted on Sep 28, 2010
check for power at the fuel pump if no power check relay's fuses ect If you have power at the pump then most likely bad fuel pump.And yes they do quit just like that
Posted on Jun 07, 2012
Testimonial: "Thanks! We are picking up a multimeter to check it out!"
Tips for a great answer:
Mar 04, 2013 | 2001 Ford Escort ZX2
Jul 30, 2017 | 2004 Jeep Grand Cherokee
Feb 26, 2012 | Cars & Trucks
Jun 13, 2011 | 1998 Ford Expedition
Oct 12, 2010 | 2002 Ford ZX2
Mar 18, 2010 | 1988 Chevrolet Silverado 2500
34 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: