Question about 1995 Isuzu Rodeo

Open Question

Blinkers not working on my 1995 rodeo. Checked fuses ok. Thinking maybe the flasher unit but can't find where to get to it.

Posted by Graham Lovell on


5 Related Answers

Curt Downs

  • 1779 Answers

SOURCE: Blinkers stopped working

Your F--150 has 2 flashers, emergency and turn signal. Both are mounted on the fuse block under the dash. The turn signal flasher is mounted on the front of the fuse panel, the emergency flasher is mounted on the rear of the fuse panel. so replace the turn signal flasher should solve the problem. Let me know how it goes.

Posted on Oct 20, 2008



  • 1 Answer

SOURCE: no brake lights of blinkers 1990 dodge dynasty

While not likely, it is possible that the light bulbs in both sides are have bad filaments. Turn on ignition key (but don't start engine). Then turn on parking lamps (first detent or "click" on headlamp switch). Walk around car and look for illumination on front parking lamps and rear tail lights. Turn on the right turn signal. Are those (right hand) lamps now changing brilliance? Try the left turn signal in the same manner. Are those (left hand) front and rear lights changing briiliance? Take note of any positions that did NOT change briliance when the turn signals were activated. If NONE changed briliance, you either have a bunch of bad bulbs (unlikely) or a bad flasher (more likely) or a bad turn signal switch (most likely) or perhaps wiring problems (possible if the car has been in a collision or has been "worked on" by some "non-expert" mechanic). Check the action of the emergency flasher control switch located on the steering column (facing up). Pushing it in (down) should result in the button going to two different heights alternately (low, high, low, high). You could just have bad flashers or corroded flasher contacts! Good luck!

Posted on Dec 29, 2008


gerry bissi

  • 4388 Answers

SOURCE: 2003 F-250 Flashers won't work

I'm leaning towards a bad multifunction switch on your steering column.

symptom chart

  • The turn signal lamps are never on
  • Central junction box (CJB) fuse 27 (15A).
  • Circuitry.
  • Electronic flasher.
  • Multifunction switch.
  • CJB.
  • Go To Pinpoint Test K .

  • The hazard lamps are inoperative
  • Central junction box (CJB) fuse 18 (20A).
  • Circuitry.
  • Electronic flasher.
  • Multifunction switch.
  • CJB.
  • Go To Pinpoint Test M .

Multifunction Switch Removal and Installation
  1. Remove the ignition switch lock cylinder.
    1. Insert the ignition key into the lock cylinder and turn to the RUN position.
    1. Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
  1. If equipped, twist the tilt wheel handle and shank and remove.
  1. Remove the upper and lower steering column shrouds.
    1. Remove the screws.
    1. Remove the upper and lower steering column shrouds.
  1. Remove the multifunction switch.
    1. Remove the screws.
    1. Disconnect the electrical connectors.
    1. Remove the multifunction switch.
  1. To install, reverse the removal procedure.
You can do this. You don't even have to remove the steering wheel.
Buy the part at for about 35% off too.

Please rate as fixya if this fixes your issue and report back on success. good luck.

Posted on Mar 05, 2009


  • 2 Answers

SOURCE: Dash Lights 1995 Isuzu Rodeo

with lights off and battery disconnected remove the twist knob on the dash that brighten and dims your dash lights and jump the two prongs with a jumper wire. connect battery and turn lights on all your dash lights should work now. if thay don't take the dash screws out and replace the bulbs, it's really easy if you have mechanical skills if not consult a friend that does. now you know the dash light dimmer switch is bad and they are hard to find i found mine in a wreck but until i did i just left the jumper wire in place (about a year and 1/2)

Posted on Jun 01, 2009


  • 3 Answers

SOURCE: cant locate thre blinker flasher fuse on 1995 buick regal gs

I've had the same problem in my 1994 buick. The switch is in the steering column. Must remove aribag etc... I took mine in and got it fixed for $250.

Posted on Aug 02, 2009

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Flasher repair

First, check your bulbs by starting up the vehicle and turning on the blinkers, then go around to check them. Also check to see if your emergency flasher work.
The fuses are either behind the glove box or under the dash on the driver's side.
Look on fixya, someone had the same problem back in April and several ideas were posted.
Good luck!

Jul 01, 2014 | 1995 Isuzu Rodeo

1 Answer

Have a 1995 Ford Escort with 170000 miles on it. About a week ago, I noticed that the blinkers were not working. I heard the clicking sound, but there was no light on the dash or outside to the bulbs. When...

blinkers have a relay ,,that is the clicking
clicking all the time means the indicator switch and relay are

if all the wires are running through the relay correctly

check all the earths at the bulbs


Mar 22, 2017 | 1995 Ford Escort

1 Answer

Both blinkers just stopped working. I checked fuses and bulbs, everything was fine.

Check the flasher unit. On most vehicles it is cylindrical metal can and is plugged into the fuse block under the dash, sometimes it's attached to the steering column, or is mounted in the dash maybe behind the glove box.

Mar 21, 2011 | Toyota 4Runner Cars & Trucks

1 Answer


It should either be in your fuse box inside your car but most likely it will be inside the engine compartment in a black box and labeled.

May 27, 2010 | 1997 Isuzu Rodeo

2 Answers

I have a 1995 Cavalier and no owners manual. My blinkers don't work but the flashers do. I want to check the fuses and can not locate the fuse box.

You'll have 2 flashers, usually in fuse panel area, one is for flashers & one is for blinkers. If they look the same, swap them around and see if opposite happens, and if so, just buy another flasher when you get to autoparts store.

Jul 09, 2009 | 1995 Chevrolet Cavalier

1 Answer

My right blinkers wont work

well rule out the flasher unit first by replacing it... cheaper to replace that and rule it out then replacing the switch and finding out it was the flasher..


Please take a moment to rate this solution... thanks

Jan 26, 2009 | 1999 Chevrolet Camaro

1 Answer

1992 Dodge dakota

you have a bulb out or your relay is shot

Oct 07, 2008 | 1992 Dodge Dakota

Not finding what you are looking for?
1995 Isuzu Rodeo Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14847 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides