Question about Peugeot 206

Open Question

2005 peugeot 206 intermitent fuel pump control out of range error code, how do i fix this ?

Posted by Andy Yates on

Ad

5 Related Answers

ginko

Ginko

  • 19396 Answers

SOURCE: fuse box diagram peugeot 206

Check the website below:

Peugeot 206 Fuses.

Posted on Mar 28, 2009


therealgraha

  • 55 Answers

SOURCE: car wont start on 206

you must fill the fuel filter housing with diesel to eliminate air pocket. if you don't have diesel, fill it with automatic transmission fluid. it will smoke for a few seconds, but it will run so fuel pump can catch up. don't touch throttle for a few seconds till you know that it is running on diesel and the tranny fluid is all used up.

Posted on May 24, 2009

Ad

scj103

  • 104 Answers

SOURCE: how do you bleed a peugeot 206 1.9 diesel fuel

TBH you shouldnt need too. There is a hand prime pump (black rubber egg) which will bring the fuel up. Pump this till its hard. Crank the engine for 5 seconds. Pump the egg again, crank again, probably three or four times, and the engine should start. It will probably stall, but do it again, and it will start and run. Once running, keep it running at a fast idle to get the last bits of air out.

Posted on Jul 12, 2009

Wahs Team

  • 215 Answers

SOURCE: my peugeot 206 diesel keeps cutting out, now it

In my opinion cut off problem occurs if engine is not getting sufficient fuel and/or air. Clean the air filter, turbo filter and fuel filter. Check the continuity of diesel flow from filter to hdi pump. If you haven't found any problem there then the possibily the hdi pump and injectors section needs to be checked. If the car has done more than 100000 miles then clean inlet and outlet manifolds including check of turbo and EGR valve. Do everything whatever possible before you take your car to garage. If there is no luck then let your car diagnosed and check any error code recorded by ecu.

Posted on Oct 13, 2009

mike hayward

  • 279 Answers

SOURCE: how to turn off the airbag on peugeot 206 1.6

there should be a key switch inside the car somewhere you need to turn it to the off position with the ignition key
(it will probably be some where on the dash, in the glove box or center console)

Posted on Dec 08, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Peogeot 206 HDI has a diagnostic error code P14660. The engine turns but it doesn't start


that fault code is too high for a Peugeot 206 with OBD2

i checked all the Peugeot car forum sites for answers
on that code

P14660 no mention
PO4660 no mention
PO1466 no mention

need to start back old school diagnosis

fuel pump ... spark at plugs

this is the world list of all PO obd2 fault codes
http://www.troublecodes.net/pcodes
26328114-dr1l0prezoqh0gobrdoiolxi-5-0.jpg

Oct 26, 2016 | Cars & Trucks

1 Answer

Peugeot 206 error code p14660


that fault code is too high for a Peugeot 206 with OBD2

i checked all the Peugeot car forum sites for answers
on that code

P14660 no mention
PO4660 no mention
PO1466 no mention

need to start back old school diagnosis

fuel pump ... spark at plugs

this is the world list of all PO obd2 fault codes
http://www.troublecodes.net/pcodes
peugeot-206-error-code-p14660-dr1l0prezoqh0gobrdoiolxi-5-0.jpg

Oct 26, 2016 | Peugeot Cars & Trucks

1 Answer

I have a Peugeot 206 sport with electrical problems


my 206 has many electrical issue and while driving normally it will suddenly want to stop or start jerking.

Dec 03, 2012 | 2005 Peugeot 206 1.4

2 Answers

My peugeot 206 diesel keeps cutting out, now it


In my opinion cut off problem occurs if engine is not getting sufficient fuel and/or air. Clean the air filter, turbo filter and fuel filter. Check the continuity of diesel flow from filter to hdi pump. If you haven't found any problem there then the possibily the hdi pump and injectors section needs to be checked. If the car has done more than 100000 miles then clean inlet and outlet manifolds including check of turbo and EGR valve. Do everything whatever possible before you take your car to garage. If there is no luck then let your car diagnosed and check any error code recorded by ecu.

Oct 13, 2009 | 2005 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

scj103

Level 2 Expert

104 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...