SOURCE: Hyundai Santa Fe Windscreen Washer Motor Fault
try taking a pin and cleaning the holes on the squirters and if that does not work check the washer pump it is located on the washer fluid tank
SOURCE: Hyundai Santa Fe 2005 won't shift into first gear
Most likely the o-ring seal between the torque converter and the transmission is going bad. Get that transmission rebuilt pronto before serious damage is done! But first, have a mechanic drop the transmission pan and look for signs of a very thin silvery film coating the inside of the pan. If found, then the transmission definitely will have to be rebuilt, and the torque converter will also have to be replaced since embedded metallic particles in the old torque converter will eventually come loose, due to wear of the clutch plates within the torque converter, and eat up the rebuilt transmission. Now, here is the deal once the transmission has been rebuilt:
Change the transmission fluid and filter once a year -- no matter what! If you do this, then you should never have any more problems with the transmission.
SOURCE: radiator& condenser fan motors still not
If you have power at the fan unit the problem is the fan itself. If you don't have power at the fan unit, that will be a different story and much more difficult problem to diagnose. If that is the case then you have an ungrounded circuit causing it to fail and the problem is in the wiring. The only real way to test it is to disconnect the wires from the fan, start the vehicle and turn the AC on, that will put the fan in a constant on situation, then check the wires for voltage. If there is voltage warm the vehicle up and turn the AC off and retest the wires. If you have voltage in both situations then the fan unit itself is faulty. If you don't in either situation you have a short in the wiring harness. There is a slim possibility the problem could be the ignition switch itself but you need to test this fan power circuits first.
You do have drive and reverse,if you have park and neutral.It just the transmission cant transfer that power a new or rebuilt is the solution
have you checked cables for loose connection ?/bare wire underneath ?
169 views
Usually answered in minutes!
×