SOURCE: 1996 Plymouth grand voyager se-need diagram
The BCM is located on the drivers side under the the steering column. It is behind the fuses and to get to it you have to remove the bash board plastic, than a pice of metal and than you have to remove the fuses box. It will take you approximately 20 min to remove everything. Once you remove the BCM you need to take note of the Part Number P/N. It has to be the same P/N on the replacement BCM. You can use any BCM from years 1996-2000 but make sure the electrical configuration is the same as yours (Power windows, alarms, etc.). I bought my BCM on the junk yard for 35 dollars and my car works perfectly.
I hope this may have assisted you,
Tom
SOURCE: where is the body control module located?
the body control module is located on the drivers side of the vehicle under te lower kick panel yor flasher unit is located there as well so to find it easier turn on your hazard flashers and follow the clicking its in a junction block
SOURCE: need wireing digran for 1996
When the ECM is replaced you need to have it reprogrammed. It may run the engine for a bit but there are t many variables to keep it going. Some auto parts stores are doing this now. call around. Much cheaper than a dealer. If you had it reprogrammed then you need to check the codes. This will give a direction to go.
Randy
SOURCE: wiring diagram for 2000 plymouth grand voyager
Some of the diagrams you can get from places like autozone online, or research the particular component online. Things like body components may require you to buy a shop manual.
567 views
Usually answered in minutes!
×