My actros radio blocked by entering wrong code . now i know the code but how to remove the message blocked and to write the correct code?

1. That usually means that someone entered wrong security code too many times. Try disconnecting the cars battery for approx. 15 minutes. Reconnect battery and see if radio just says code without the e. If it does then you will have to try entering the correct code. If you do not know the code you will have to remove the radio and get the serial # off the radio and contact Honda to get code. You will have to go to the Honda dealer and prove you own the car.

when you turn the vehicle on after radio shows message enter code, if it is the correct code after entering last digit of the code radio should unlock, if not suspect faulty radio and replace. or you have the wrong code, also try unpluging the battery and repluggin it to reset the radio

Go to this site www.radio-codes.com

If the wrong code has been entered too many times the radio is likely to be permanently blocked.

Each time a code is entered wrongly or the wrong code is used there will be a waiting time before the code can be tried again and each time that waiting time will be longer; up to several hours.

It is important to enter the code and activate the radio precisely so check the procedure in the manual before starting then if the code won't go in assume you have the wrong code.
The correct code can be purchased from the dealer or various internet sites offer "find your code" services. Alternatively it is possible to have the radio re-coded or decoded. Bear in mind the radio could be permanently blocked and effectively useless..

try gumtree.com

This will have to done by the dealership by the vin number make and model.Although there are some who will give you a code on the internet by giving them the same code they pretty much just give the info to the dealership and sell you the same coee

Disconnect the battery overnight and try again.

when you use the "preset keys" (the keys on the radio with numbers on them) to enter the code, each time you press a code number, a letter appears [c, o, d, e]. once the word is spelled out, from entering the correct 5 digits, the radio is reset, ready to go.

BUT if you miss a number, enter a wrong number, whatever, each number pressed, still makes a letter appear from the word "code". once the word is spelled out, by entering ANY 5 numbers, if ANY of the 5 is wrong, the radio displays a message "Error" and then a number 1 thru 10.

When you see the word "Error..."

the next preset button you push, starts the whole thing over again. The radio says "Enter code". That is when you enter the 1st of the 5 digits, the letter C appears, enter the next digit, the letter O appears, enter the next digit, the letter D appears, enter the last digit, the letter E apperas, the radio is reset, ready to go, if you got the 5 correct numbers entered.

you have 10 chances to enter the right 5 digit code. Each wrong try of 5 digits yeilds a display of "Error 1", "Error 2", "Error 3", etc 'till you get to 10 incorrect tries of 5 digits each.

If you dont get it right in 10 tries, you have to leave the radio "on" for an hour, then it will let you start the 10 tries over again.

Good luck!

leave the radio on for a few days, with the wait displaying, it will display CODE after a few days, 2 - 3 days, then enter the correct code , everytime u enter a wrong code the time increases.

I had a similar problem with my 94 Saab 900, I needed to reset the radio code because the one in my user manual was wrong. If you can remove the radio from the dash (you can buy a tool or make it with metal clothes hangers). Pop the radio out and the correct code will sometimes be written on the top of the radio.

Either way entering this correct code did nothing for me on startup. But the solution is far out - turn the ignition key to "on" without starting the engine so the electrical system is on. Then leave this for 1 hour. When you return the HID will display "enter code" (exactly like if you hold down the BAND button - but that doesn't work like this does). Now enter the correct code.