How to clear Antitheft program activated message on the screen at ml350

The reduced power message to a protection program that the ECU activates when certain engine and transmission issues are detected. The engine light should be on and OBD2 codes will be stored. You need a code reader to find these codes and their meanings. Please borrow or buy this tool and write back. Also what do you mean the starting system is locked out? I don't know if you are writing about the antitheft system, shift interlock or a bad starter.

have you checked both front and rear sensors?

need unlock code or take to any GM dealer to unlock

my radio isint working

according to my alldata book a 2007 model can only be reset by the dealer ,but look on some of the chinese automotive software sites on the web as no doubt they may have cracked it and produced a small unit to clear the service inspection light by now

punch the four digit code into the radio then punch auto, and the security system should be activated

Hello. All of the warning lights are activated by a sensor. In this case since the engine oil level checks out fine the cause of the engine oil warning light is a bad sensor. You should be under full warranty. Have the dealership change the sensor. Joe

Press services ,left of screen,then system,right ofscreen
Use up/down/left/right on rotary button bottom right/screen

Dealer needs to re-program your SAM.

no way around this.the vehicle will not start without proper signal from pats key.if your using the same keys you always use there must be a problem with the passive antitheft system.but if you or someone else have attemped to start the vehicle with a key that is not programed to this vehicle the antitheft will kick in and you might have to have get your vehicle scanned and the keys reprogramed.you could try disconnecting the battery for at least 10 min this will clear the memory,then try to start.if still does not start there is a problem with antitheft.