3/16". Use copper nickel alloy when replacing, your hands will thank you!
If u are talking abt the bleeder screws , they’re probably 8 or 10 mm
SOURCE: Flare nut wrench size?
try metric size. a flare wrench is an closed end wrench with a little **** in big enough to to slide over the line and then around the bolt its grabs mor of the bolt than a regular wrench
SOURCE: rear brake lines 99 ford taurus se
most of the time the auto parts can give you the right length.but if i had to gess your looking at 6to 7 feet long 8 ft at the most. it would be a good i dear to re place the line going to each wheel to . because those will be the next one to go good luck
SOURCE: replacing the brake line on a 1992 chevy lumina
Have it done by a pro because any connections have to be double flared, then the brakes have to be bled.
SOURCE: i have a 99 lumina i have no brake lights and
check for power to brake light switch and comming out, sounds like bad brake light switch
Testimonial: "yes this did it. i have brakes again. thank you"
798 views
Usually answered in minutes!
×