Question about 1998 Jeep Grand Cherokee
If you are using standard transmissions they make adapters for the bell housings. For automatic check with a wrecking yard.
Posted on Apr 22, 2019
You need to remove all the skrews from the door. Normaly there is one in the handle of the door, one behind the in door lach handel and one under the bump out for the arm rest on the door. Than you need to take a flat head skrew driver slowly priying the panel off. There are plastic clips on the backside of the panel it is ok if you brake a few.
Posted on May 01, 2009
First, if the noise is from the upper part of the engine and is more of a tapping than a knock, likely you have a problem in the valvetrain, most often a bad lifter or worn rocker arm. If the noise is low, deep inside, the noise is from a bearing. This is generally accompanied by lower than normal oil pressure. Regardless of the underlying cause, correcting the cause will not stop the knock. To do that correctly, the engine needs to be removed and all crankshaft bearings and the crankshaft itself need to be replaced (crank can sometimes be "undercut" and thicker bearing shells can be used depending upon the amount of wear.) If caught very early, sometimes only one bearing can be replaced in-car, but in 99% of all cases I have ever seen, most will fail again, sometimes more severely if done this way.
Posted on Dec 10, 2009
Tips for a great answer:
Mar 02, 2015 | Pontiac Cars & Trucks
May 31, 2013 | Cars & Trucks
Apr 01, 2012 | 1998 Jeep Grand Cherokee
Nov 28, 2010 | 1998 Jeep Grand Cherokee
May 13, 2010 | 1998 Jeep Grand Cherokee
Dec 31, 2008 | 1994 Jeep Grand Cherokee
123 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: