I want to run a pre powered Subwoofer and want to be prepared when I do ot.
There are no such ports on the stock head unit.
Testimonial: "Yeah you are correct sir I just figured I'd cheat s bit and get some know what and how from guys like you. Thanks again!"
Thank you very much. Big help!
By the way, it is not hard to access the back of the unit. The facia on the console is usually held in with spring clips.
You can see pics of the back on ebay.
Man, you're the best! Now I know what I'm getting into and I can have everything ready that I need. Unbelievable Thanks a million!!!!
×
Rca jacks and sockets are like the plug ends on a microphone or power adaptor
if you cannot see that sort of socket then you do not have them
Testimonial: "I mean before I rip the dash apart, mine did'nt come with the CD changer but I think the previous owner took it out. Just so I know what i'm getting myself into b4 I do so, so im prepared."
SOURCE: Location under dash for fuse block for 1997 Buick
on the passenger side under the dash there is a cover panel. take the screws out and pull it off, carefull the light needs to be removed after you do this. the fuse panel will be close to the left. oh by the way. their are 4 fuse boxes on this model.
SOURCE: Rampage BA-100 200W amplified subwoofer
Actually. I don't think you have to wire a remote switch from the radio to the amp on this product. This powered subwoofer supposedly has automatic signal sensing turn-on circuitry. I have the same problem. So I think I'll try to just hook up the power (to the battery), ground and the + / - speaker wires to one of the back speakers in the car and see if that works.
SOURCE: 1997 Buick Park Avenue
This is the diagram but you should have factory belt diagram sticker is still somewhere under the hood
If not:
http://www.mvreader.com/multiview/dayco/zoom.php?zoom_item=C0001D&l=n&catalog=auto&category=
To replace the serpentine belt on a V6 3800 you must jack up the motor and remove a motor mount. You must then use a breaker bar with a socket (13/64") and pull it toward the front of the car to release the belt tensioner. Put the new belt on, tighten it, put the mount back on, and lower the jack.
Driving without a belt can cause the motor to overheat, will cut power steering, and will not recharge the battery, so you should probably get a tow
Good Luck
SOURCE: 1991 buick park avenue will not run fuel pump is good and replaced the fuel filter
http://www.fixya.com/cars/t1810766-1991_buick_park_avenue_stop_running
Check out this link. It may help you with your problem.
SOURCE: Buick park avenue ultra 1997 spark plug wires
Here is a firing order diagram for that vehicle, and let me know if you need any help to understand this diagram, or if you require any further assistance.
103 views
Usually answered in minutes!
×