Repair your vehicle right away. Just click on the link I attached 1990 MAZDA B2600i PICKUP REPAIR MANUAL
SOURCE: Front Brakes
Replace the brake pads, then sand the lines and spray them with undercoating. If you dont want to sand lines just spray the undercoating. They will last longer if you sand them. This is available at your local auto parts store
SOURCE: clunking noise and brakes grabbing
Check your brake hardwares make sure its in proper places and not loose. you would also want to check the caliper sliders, clean and lubricate with silicon lube. and lastly make sure that rotor backplates are not touching the rotors, you can do this by spinning the rotors while the wheel is off, if it is, then pry the backplates a little. hope this would help, goodluck.!
SOURCE: Need to replace Antenna on 90 Mazda B2600i Truck
NO, just the plastic wheel arch liner underneath the fender. The chrome nut on the base of the antenna will unscrew and then it will go downwards into the hole and come out from the underside
SOURCE: Mazda B2600i
are there any fault codes present? i was looking at the fuel injection diagram on autozone.com and the only thing i can see that controls injector pulse width is the pcm. are all the injectors open for 15ms? you should also check fuel pressure. if you want to look at the diagram, go to autozone.com. register and enter you car. select repair guides, chassis electrical and the wiring diagrams
SOURCE: Broken brake line on 1990
1990 Chevy 4.3 l engine runs rough at idle half the time-- sometimes it's OK, other days it's rough and can smell raw gas, as tho it's running rich... any ideas?
146 views
Usually answered in minutes!
×