SOURCE: hand brake nissan pathfinder
If you lift the hand brake you should find an adjustment nut (I think it is 10MM). Tighten that and you should be good to go. Be careful, it doesn't take much to adjust - turn gradually/slowly.
i hope i was able to help you with your problem! tc!
SOURCE: proton jumbuck electrical fault on
I had a similar problem with my jumbuck,2 sets of keys only one worked. Replaced battery now ok.CR2032 ,tednanango
SOURCE: hi hope you can help i have a proton jumbuck and
it is possible that you have a blown fuse, HIGH & LOW beams are usually on different fuses, most likely for safety reasons so as if either one blows at least you still have lights, check the fuses in the fuse box......hope this helps......cheers.
SOURCE: Proton Jumbuck Hazard Indicator lights not working.
may be you should make a diagnostic and you can do it in a garage or you can do it by yourself if you want to do it by yourself you need some tools and you can find some good ones here: diyobd2.fr
Probably a bad bearing on the A/C compressor. Replace the compressor. Bearing is on the inside, not the pulley bearing.
401 views
Usually answered in minutes!
×