At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The flashing light tells you there is a problem in the system. A mechanic would check to see if the system is charged with freon then check the electrical circuit for the compressor.
Have it checked by a professional as soon as possible, airbag has a problem wich can be as simple as a short in the wiring or as harmful as the possibility of deploying airbags without any warning. Please take advice.
Slide the temperature lever all the way to the left (full cold).
Turn the Mode Control to ‘panel’ (the one that sends air to your face only).
Turn the ‘blower switch’ to all the way to full.
Now go to the leftmost three buttons. Press and hold the top one (rear wiper on constant) and the bottom one (rear wiper washer fluid) until the lights come on solid then begin to flash, and then you can let go.
The AC will now calibrate. You will feel the air blow out of all the different zones at different intervals and see lights
come on and go off. Then after a minute or two the top button you
pressed will be slowly flashing. This means it has been completed.
Try this and see if it works. Let me know. Start your van. Then slide
your temp lever all the way to the left (full cold). Then turn the Mode
Control to 'panel' (the one that sends air to your face only). Then
turn the 'blower switch' to all the way to full. Now go to the leftmost
three buttons. Press the top one (rear wiper on constant) and the
bottom one (rear wiper washer fluid). Hold these two for a few seconds.
Once the lights come on solid then begin to flash you can let go. The
AC will now calibrate. You will feel the air blow out of all the
different zones at different intervals and see lights come on and go
off. Then after a minute or two the top button you pressed will be
slowly flashing. This means it has been completed .
Press the last flashing button and you are done.
disconnect a/c compressor connector and reconnect make sure the connector is tight....my van was doing the same thing and after i did that it works great no more flashing lights
Sounds like its gone into programming mode.
All you need to do is start your van. (if you are unsure what knob or lever is which I am looking in the manual for proper terms) Then slide your temp lever all the way to the left (full cold). Then turn the Mode Control to 'panel' (the one that sends air to your face only). Then turn the 'blower switch' to all the way to full. Now go to the leftmost three buttons. Press the top one (rear wiper on constant) and the bottom one (rear wiper washer fluid). Hold these two for a few seconds. Once the lights come on solid then begin to flash you can let go. The AC will now calibrate. You will feel the air blow out of all the different zones at different intervals and see lights come on and go off. Then after a minute or two the top bottn you pressed will be slowly flashing. This means it has been completed (I actually let it run for 5 more minutes just in case something else started blinking). Press the last flashing button and you are done.
×