SOURCE: How do I change the 3 spark plugs on the back of engine
The upper intake has to be taken off to get to them. Yes it is a pain in the but, not too hard to do, just bothersome to do this to be able to change plugs. Make sure to be careful when loosening the intake as the head is aluminum and you can damage it if you take a gung-ho approach. You will need to replace the gasket but it is only around 12 -15 $ .
SOURCE: change spark plugs on 2007 Toyota Camry
In servicing the spark plug . If the owner will be the one to change the spark plug then. the owner should locate the spark plugs . then prepare the equipments that is going to be used to change spark plug .First disconnect the spark plug cable to the spark pug . Then use the equipment to take the spark plug off to the engine. The spark plug should be twisted counter clock wise using the equipment to remove the spark plug.Then replace the spark plug.In returning the spark plug ,using the equipment you have to twist the spark plug clock wise . Then set the distributor shaft turn it according to the proper firing order that will be set to the spark plug if it is 1,3,4,2. Then the distributor shaft mark will be on 1.If 2,3,4,1 then the distributor shaft mark will be on 2. Then connect the spark plug cable , after connecting the owner have to test start the car so that to if it back fires .If it back fires then the owner have to repeat again the setting of the firing order of the spark plug until it will not back fires.If the owner don't have time to do the job in servicing or changing spark plug then the owner have to go to a car mechanic and let them change the spark plug.
SOURCE: I need a spark plug wire diagram for a 1992 Toyota
1992 Toyota Camry Sedan
3.0 liter DOHC V-6 (3VZ-FE)
Cylinder # Front, passenger to drivers side 2-4-6
Cylinder # Back, passenger to drivers side 1-3-5
Distributor 12 O'clock post # 6 cylinder
10 O'clock post #1 cylinder
8 O'clock post #2 cylinder
6 O'clock post #3 cylinder
4 O'clock post #4 cylinder
2 O'clock post #5 cylinder
Good luck and hope this helps.
SOURCE: I removed my spark plug wires and forgot which
The firing order is 1-3-4-2
Number one is the one at the pulley end of the motor and number 4 is at the flywheel end of the motor.
System uses a Distributorless Ignition System (DIS) with 2 ignition coils. Cylinders No. 1 and 4 use the same ignition coil. Cylinders No. 2 and 3 use the same ignition coil.
SOURCE: Belt routing diagram for1999 Toyota Corolla
Thats a 98 belt routing same engine. 99 wouldnt load
1,019 views
Usually answered in minutes!
×