SOURCE: kia caren 53 model handbrake ajustment
2 10 mm wrench's and a screwdriver are needed. lift the rubber boot and adust the cables with the wrenchs by loosening the locknut first then take the slack out of the cables evenly while not letting them turn by holding them with the screwdriver . when you can set the brake on the third or fourth notch or click then its perfect,
SOURCE: what is lambda control at lean limit for proton gen2
Air/fuel mix is too lean and beyond computer limits of adjustment. Check for vacuum leaks , restricted fuel filter or low fuel pressure.
1ST 11LB/FT
2ND 22LB/FT
3RD 33LB/FT
4TH 44LB/FT (FINISHED) THIS IS THE TORQUE PROCEDURE FOR HEAD BOLTS
run the fault codes
best place to start to determine a problem
342 views
Usually answered in minutes!
×