How do you put in the third row seat in a 2006 Nissan pathfinder?

SOURCE: third row seats

A little plastic bumper, located on a metal tab on the inside of the bottom seat cushions breaks off. It is supposed to hit the seat back release and allow the back to fold down when you push the bottom cusion in all the way. I finally just bent the metal tab up so it would hit the release and that fixed it. (Look for the broken palstic pieces under the seat cusion area as an indication) The dealer replaced the plastic part several times... a waste of time.

Dar

• 2007 Answers
• Posted on May 31, 2009

SOURCE: How do you remove the headrests on the front and third row seats?

There is a small hole at the base of the headrest post. Use a nail and push in the hole to release them.

SOURCE: Mounting third row seat in 2008 Suburban 1FL, LS 1500 - Fleet veh

I drive a 2008 Suburban LT and my company has a true work "fleet" suburban. The only difference between these two that I have is the back of the fleet vehicle has a thick rubber mat in the back with no seats. After removing the black mat I found that the channels and rods that the rear seats clip into are present. The third row seats are installed by clipping them in no bolts or tools are required.

SOURCE: how can i replace the fuel level sensor for a 2006

The fuel level sensor is located inside your fuel tank

SOURCE: third row seat in ford explorer stuck in down

my third seat is stuck in the down position . press switch to raise i hear the motor but nothing happens. 2006 ford explorer