Question about Infiniti Cars & Trucks

Open Question

I found out with the EX35 infiniti seat that the seat is not out of the track, it is the plastic cover. that is up to high and rides to the right of the track.

The plastic cover goes over and around the end of the track in the back toward the back seat Anyone know how to fix this? Thank you Christene Jowers

Posted by Christene Jowers on

Ad

5 Related Answers

alicantecoli

Colin Stickland

  • 22485 Answers

SOURCE: Peugeot 406 SV rear seat removal

take it you have done it------- two brackets at front of seat

Posted on Nov 20, 2008

Ad

Anonymous

  • 1 Answer

SOURCE: I have a 2004 infiniti sedan g35... the pass side seat does not

i just fixed this problem - the switch is bad - take out the seat - 4 bolts on the bottom 4 corners and then remove the whole switch - either buy a new one around $200 or unsauter the switch and clean it but be careful as there are a lot of parts inside that can fall out. i cleaned mine and it works fine beats spending the money.

Posted on Apr 24, 2009

Ad

Richard Scordino

  • 6982 Answers

SOURCE: window problems electric powered off track

Unless the motors were replaced at one time, the only bolts holding the window to the regulator are at the slides. any hardware that fell apart should be inside the bottom of the door. Panel removal is pretty simple..only hidden fastener is on the edge...small reflector has one under there.
Haynes makes a good reference for that car for about $20.

Posted on May 22, 2009

SOURCE: remote problem

there is no seperate battery in the car for the keyless entry system, either the remote needs to be re-programmed at a dealer with the proper scan tool or the remote itself is bad.

Posted on Jun 19, 2009

chris quammen

  • 811 Answers

SOURCE: The back seat latch on my 2005 Honda CRV not not

check to see if parts are jammed in the path of movement

Posted on Sep 12, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does it die when turning left after stopped at traffic light?


Go to your browser type in 2008 infiniti FX35 diagnosing intermittent stalling issues ; and its by UNDERHOOD SERVICE . It tells what you should check . hope this solves you problem .

Dec 22, 2015 | 2008 Infiniti EX35

1 Answer

I have a 08 infiniti ex 35 journey with 75k,it had an overheating right now has a bubbles on the radiator at engine satrted ,white smoke in the morning associates to water occasionally. My question is ,if...


Yes a head normally can be milled (shaved) down and a new gasket installed to fix the engine. Be sure to fix WHY it overheated too. Of course change oil and coolant too!

Mar 23, 2015 | 2008 Infiniti EX35

1 Answer

I have and 04 avalanche and the seat is stuck ! I


There is a small cable on each side of the the seat, they are covered with a hard plastic cover. If that cover breaks, it will let the cable come out. When one side of the seat gets off track from the other side , it wont move. The cable is flexible, the cover holds them straight. The cover is either a dealer item or junkyard.

Sep 06, 2014 | 2004 Chevrolet Avalanche

1 Answer

How do you remove the "TRACK TRIM" from the front seat of my Honda Ridgeline.


check for screws or caps covering screws in the plastic trim.if there aren't any take a flashlight and look under the seat for clips that release the plastic, it may just pry off.

Mar 19, 2014 | 2008 Honda Ridgeline RT

1 Answer

How to replace drivers seat motor in 1999 caddy de ville


Remove the seat assy, and remove the track assy. I havnt found where you could replace the drive motor by itself

Nov 03, 2013 | 2004 Infiniti I35

1 Answer

Infiniti I35 2004 with all options and 80,000 miles. The driver's electric seat is jammed at the back position and tries to go forward whenever the car starts and all it can do is make a grinding...


sounds like the motor is bad easiest and cheapest way to fix would be to get a complete seat from the Junk yard the seat should come with all the motors and tracks all you have to do is unbolt old seat and bolt down new one only draw back to this is seat might not be same color but there two ways to fix that first u could just get a set of seat covers Or you can take the track and motor off new seat and install them on the old seat

May 11, 2011 | Infiniti I35 Cars & Trucks

1 Answer

How do I remove the center console from an 2001 Infinity QX4


there will be a few screws you'll need to get to.
some will be on the bottom, to the left and to the right of the console, where the seat is. You may need to move the seat forward all the way or back all the way to gain access. Look for round plastic covers that are hiding the screws.
Also, check inside your console. Lift up the mat or cover that may be on the bottom of your console inside. There may be a screw or two there. Same with the cupholder rubber cups. Finally, at the front where the console meets the dash, there will be a few screws or locking tabs. Then carefully pull it up from the back. It should pop out.

Jun 11, 2010 | 2004 Infiniti QX4

1 Answer

How do you take the driver's seat out of a 1991 jetta?


Unplug the seat belt warning plug, under the seat. You'll need to remove the right side seat track cover, it has 2 plastic inserts holding it down, push the little pin thru the insert. On the other side, at the end of the track, remove the black seat stop. Then at the front of the seat, on the bottom, in the center of the seat, there is a small seat track, at the front of the bracket, you will a screw and a 10mm nut. Remove them, lift up the seat lever (like you were going to move the seat up or back) and slide the seat back until the seat is out of the tracks.

Mar 17, 2010 | 1991 Volkswagen Jetta

1 Answer

One side of driver seat does not move smoothly or at all.


Unfortunately you need a new seat track assembly. I'm an infiniti tech and have replaced MANY of these tracks.

Jun 08, 2009 | 2004 Infiniti FX35

3 Answers

Driver's seat unable to move forward or backward


There are plastic gears connecting the track to the seat assembly. Whne one of these strip the seat will only work or move to one side. Infiniti does not sell a simple fix. You are looking at buying an entire seat assembly complete with the module for all the electronics. It will be at a cost of around $950 - $1000. Once that is in, Infiniti must program the seat to the brain of the car, only then can you reset your memory settings.

May 19, 2009 | 2004 Infiniti G35 Sport Coupe

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6528 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...