Question about Cars & Trucks

2 Answers

My 2001 chyrsler concorde 3.2 engine turns over but no spark

Posted by john burnett on

Ad

2 Answers

spacil

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 21 Answers

Where are you checking for spark, at the plugs, ot the coil(s)? First make sure your coil is producing spark, if it is then it's most likely your spark plug wires that are the problem. If you've got no fire coming out of the coil then check to see if there is voltage going to the coil. If there is it's probably a bad coil, not that unusual on a 16 year old car. If there's no power to the car it gets more difficult. Crank position sensor, wiring harness, or the ECM could be the culprit. First check the connections to basically everything you can see under the hood that goes to the engine to make sure the connections are clean, dry, and tight. Look for loose grounds or broken/missing insulation. Since you mentioned no trouble codes I'm assuming there are none so the next most likely culprit is the crank position sensor. There is a way to test these that you can probably find on the web, but typically these parts are fairly inexpensive so most people just get one and install it. After that you need to be a pretty good tech to properly test to make sure the ECM is bad or you could try a local salvage yard and just try a different one. Just make sure you get one that matches the code numbers on the one in your car. It's usually a 7 or 8 digit number, zzz zzzz or zzzz zzzz. Typically you'll only find it on the same model year and only with the same engine. Hopefully you aren't the lucky owner of a California Only emissions vehicle. Some of those can be hard to find used parts for if you aren't in California. Good Luck.

Posted on Sep 24, 2017

Ad

WelderArc

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 118 Answers

Maybe an ignition fuse

Posted on Sep 24, 2017

Ad

2 Related Answers

Anonymous

  • 1 Answer

SOURCE: how to change spark plugs in 2001 intrepid

look for 1 inch black boxes near the top of your engine pull up on them plugs should be there

Posted on Jan 24, 2009

emissionwiz

Marvin

  • 85239 Answers

SOURCE: What wires should be hot when cranking the engine on a 1998 chyrsler sebring??

That info requires wiring diagrams and we don't to have them here at fixya. Sorry
If you wish to access them for a small fee I understand you can do that here www.alldatadiy.com

Posted on Jul 03, 2012

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 chyrsler concorde no spark signal from pcm


The PCM output drivers for the coils have failed. No uncommon. New PCM is required.

Nov 11, 2013 | 2000 Chrysler Concorde

1 Answer

Were is the fuel filter on a chyrsler concord e 2000


It is on your left side of the vehicle. Jack it up and look on the top, under the car. You should see the gas lines. Follow them toward the back tire and you will run into the fuel filter.

Feb 26, 2011 | 2000 Chrysler Concorde

1 Answer

I have a 97 chyrsler conconcorde and i replaced the thermostat but is still over heating. The water doesnt seen to be circulating, any idea?


Did you run engine with rad cap off & heater (not defrost) on when you refilled the system, if not, do it & wait for your fan to come on 2 or 3 times before you top it up & put cap back on. While your running it with cap off,observe rad when engine reaches normal operating temperature, you should see increased flow in radiator, (when thermostat opens) ,then shortly after, the fan should come on. Not unusual for an airlock to cause it to overheat, so that's why I let them run through 2 or 3 cycles of rad fan coming on before putting cap back on. See if that helps.

Jun 12, 2009 | 1997 Chrysler Concorde

1 Answer

Engine problems


If it is the same size engine.Some have 2.7L and others have 3.2L.
I have a 2.7L intrepid engine in my 99 concorde.

Apr 11, 2009 | 1999 Chrysler Concorde

1 Answer

Key is stuck in ignition


Try makeing sure the shifter is firmly in park. If the shift cable gets slightly out of adjustment the key may not come all the way to the off positon.

Feb 02, 2009 | 2000 Chrysler Concorde

1 Answer

How to change spark plugs in 2001 intrepid


look for 1 inch black boxes near the top of your engine pull up on them plugs should be there

Jan 19, 2009 | 1999 Dodge Intrepid

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

23438 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...