SOURCE: 1994 Pontiac Sunbird LE Sedan radiator cooling fan not working.
Above is the diagram for a 4 cylinder. It appears that you might have a fusible link which looks like a regular wire instead of a regular fuse. If you have A/C on your car you can turn it on and this automatically should turn the cooling fan on. If I remember correctly these cars have problems with the Coolant temperature sensor located near the thermostat. It will have one yellow wire going to it. You can also try to swap the cooling fan relay with the horn relay or another relay that looks similar under the fuse block. There should be a diagram of the fuses and relays under the cover. Try with the engine off and key out try to turn the fan by hand. If it does not move freely the cooling fan motor is bad. Other than that you will have to bring to a shop to have the circuits tested... Good luck.
SOURCE: 1993 Pontiac Sunbird sensor location
Crank position sensor is located below #1 cylinder exhaust manifold side.
SOURCE: removal of a 93 pontiac sunbird LE transmission
You can remove it WITHOUT REMOVING THE MOTOR. It's not that hard, I was able to put in a new clutch system within 8 hours. Here is pretty much what you have to do:
When looking at the engine after lifting the hood, you need to put a jack under the motor and if you have it, either another jack under the trans or what works MUCH easier is an Engine hoist.
Disassemble the motor mount on the right side of the engine compartment (When looking at it from the front of the car. Remove the tire, remove the brake pad and disc rotor from the assembly and pull the nut that is holding the drive shaft in place. You can then just tap it with a hammer until you release the shaft from the hub assembly. (You know that hunk of steel or metal that your wheel studs stick out from.) You can then undo the bolts around the transmission, then use the jack to lower the motor until the trans just clears the wheel well.
You slide it out with either the jack or use the engine hoist ( I WOULD PREFER TO USE THE SECOND JACK TO SLIDE THE TRANNY RIGHT OUT OF THE WHEEL WELL)
Then use the Hoist when trying to line it back up. Put everything back the way you removed it and there we go.
[email protected] (You can message me if you have anymore questions.)
I HAVE A NINETY ONE THAT I REPLACED THE CLUTCH IN SO THAT WOULD BE THE EASIEST WAY TO MY KNOWLEDGE.
where is the cooling fan relay located on a 92 taurus
SOURCE: 1994 pontiac sunbird starter removal.
You shouldn't have to. Jack the front end up. the starter should be at the bottom of the engine towards the front of the car. Follow the battery cable from the battery to the starter. Generally there are 2 or 3 bolts holding the starter in place. Disconnect the battery before working on the car, then undo those bolts. Use one hand to hold the starter. When all bolts are off, pull the starter off.
Installation is the reverse of removal.
554 views
Usually answered in minutes!
×