2003 Mitsubishi Eclipse Spyder Logo

Related Topics:

Question about 2003 Mitsubishi Eclipse Spyder

Open Question

My 2003 mistu spyder gts seems to be floooding out and running poorly sometime especially when the engine is warm

Posted by Anonymous on

Check Price eBay

5 Related Answers

emissionwiz

Marvin

  • 85241 Answers

SOURCE: Any special tools needed to

good set of hand tools and a strut spring compressor.

Posted on Sep 11, 2008

Anonymous

  • 1902 Answers

SOURCE: i have a 2003 mitsubishi esclispe spyder gt

Basically this means that the oxygen sensor downstream of the catalytic converter on bank 1 is detecting that the converter is not working as efficiently as it should be (according to specs). It is part of the vehicle emissions system

Posted on Apr 28, 2009

Anonymous

  • 12 Answers

SOURCE: engine running rough, poor acceleration especially

well theres one or a few problems there, could be incorrect ignition timing, fuel injection malfunction, worn or dameagedignition components, faulty amission system, vacuum leak, spark plugs. a good tune up should do the trick. good luck

Posted on Jan 14, 2010

Anonymous

  • 672 Answers

SOURCE: Mitsubitsi 2003 spyder gts how do you replace rear

You must remove the intake manifold to gain access to the rear plugs. Here is a picture of an 03 spyder that I did a tune-up on!! 956ab96.jpg

Posted on Oct 06, 2010

Anonymous

  • 273 Answers

SOURCE: i have a 2003 spyder eclipse gts 3.0l how do i install a after market tachometer?

It's true that aftermarket electronics can goof up engine management electronics if improperly connected. Never use the ECM (PCM) harness as a supply for 12 volts or ground. Conversely, never supply 12 volts or ground to the ECM except from the original wiring in the harness. Some wires have voltage or ground only intermittently to the ECM as data, not power.

If your tachometer has instructions for installation in a car with DIS (no distributor), you will have to obtain an electrical diagram for your car. Some ignition systems have a tachometer output, others don't. Cars that don't have a tach output may have a wire that goes from the ECM (PCM) to the ignition module that can work for a tach signal. This set-up requires adjusting the tach (per instructions) to operate with this type of signal.

dttech suggested referring to the instructions of the tachometer that you wish to use. You can find instructions online for the better brands of tachometers, such as Sun.

Good luck from Detroit, MI.

Posted on Nov 10, 2011

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

How can i program the remote for my 2003 Mitsubishi Eclipse spyder gts?

There's a website that has all this information about all this and manuals everything totally free the re are many actually but I personally like few reliable-store for eg. .. let me know if u need help
thanks
0helpful
1answer

03 spyder gts codes

This car has a 16 pin connector under dash in on drivers side with a OBD 2 code reader it will display them
0helpful
1answer

Check engine light came on cars running fine.

If the check engine light comes on there is a problem some where in the emission control system, the vehicle may seem like its running ok but there is a problem within the system which will affect the emissions
1helpful
1answer

2003 Mitsubishi Eclipse Spyder, can't figure out why the heater blows cold air on the drivers side and warm air on the passenger side? A/C works great. I have flushed the heater core and it seems to flow...

There are a couple of possibilites. 1 Is your vehicle equipped with seperate climate controls for the driver and passenger, if so your warm/cold air motor door on the drivers side is malfunctioning. This is located under the dash.2 Your climate controls on your dash are not working properly. Hope this helps.


Please take a moment and rate my answer..........Thanks
7helpful
1answer

Mitsubitsi 2003 spyder gts how do you replace rear 3 spark plugs.

You must remove the intake manifold to gain access to the rear plugs. Here is a picture of an 03 spyder that I did a tune-up on!! 956ab96.jpg
3helpful
1answer

I have a 2003 mitsubishi esclispe spyder gt

Basically this means that the oxygen sensor downstream of the catalytic converter on bank 1 is detecting that the converter is not working as efficiently as it should be (according to specs). It is part of the vehicle emissions system
1helpful
1answer

Replaced trans, now car is stuck in limp in mode

MCARTER859: check the connections where the transmission harness and engine room harness come together. Unplug them and reconnect them I have run into more than one case with the same symptoms as yours which ended up being nothing more than poor connections.
CROSS YOUR FINGERS1
0helpful
2answers

2003 MR2 will not idle

Possible throttle control motor failure. Possible Idle Air Control Valve failure.
Is the "Check Engine" light on? Hard to determine without more info. Sorry.
Not finding what you are looking for?

113 views

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85241 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22516 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15087 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...