SOURCE: windshield washer reservoir tank is leaking how do I replace?
You must remove from it's mount and empty out any fluids that is in tank.fill the tank with water and locate where the leak is coming from. wash tank a few times and the let dry upside down. Get some sand paper (80 grit course) and sand area where leak is, clean area with a vacume or clean rag.you can buy a 2 stage epoxy that comes in an injection form and squeeze it out on a pc of paper and then get a q-tip and mix the 2 components together, fill the crack or hole generously with the q-tip, if you have to,let dry for 24 hours and mix more and put more on. let dry another 24 hours, replace tank back in it's place and you've solved your leak. (epoxy does wonders if its used properly.
Frankthetank
SOURCE: Windshield washer fluid will not pump
the windshield washer pump might be bad. It should be located somewhere on the reservoir
SOURCE: Removing the windshield washer reservoir in a 2002 Chrysler T&C
REMOVAL
INSTALLATION
SOURCE: remove windshield washer reservoir
Take off the wheel well shroud. Firdt remove the front right wheel, it will be easier. Then remove the two screws holding in the tank. Remove the two electrical connectons and small rubber hose. Next (or first) grab the filler tube and twist while pulling it from the tank as it is held in by a rubber gromet. Then pull the tank forward and let it drop down. Nothing else is holding it in except the two screws. Removing the filler tube is a must!
SOURCE: windshield washer fluid reservoir - MB ML 350
right where the lines connect to reservoir, has little black seals that leak. I recommend removing reservoir, empty it out, then use RTV silicone and place it between seals and reservoir. Let it dry for FULL day. than reinstall.
548 views
Usually answered in minutes!
×