Question about 2008 Audi TT Coupe

Open Question

Hi. Audi TT 2008 MK2,Quattro headrest removal

I wish to remove and replace but am putting BMW seatbelt holder on it

Posted by Carl heehn on

Ad

5 Related Answers

Anonymous

  • 4 Answers

SOURCE: how do you remove headrest on a 2008 silverado?

  1. Depress the button on the inboard head restraint guide to raise the head restraint to the full up position.
  2. Insert a small diameter tool into the hole on the inboard side of the outboard head restraint guide and pull upward to remove.
Note: These are head restraints and should be left in place for safety reasons!

Posted on Nov 29, 2008

Ad

Anonymous

  • 10 Answers

SOURCE: I need to remove the front headrest of a 2008 chevy cobalt lt

Push the button and pull up on it at the same time

Posted on May 25, 2009

Ad
auditech13

auditech13

  • 43 Answers

SOURCE: audi tt quattro turn light is not Blinking-stays on

Hazard lite switches go bad a lot in most audi and VW cars.  To remove you must first remove the radio.  Note you need special audi radio tools.  Next there is a cover above radio that clips in.  Remove this cover and you will be able to access the hazard light switch.  Install and test new switch before assembling.  This will take care of your issue.

Posted on May 28, 2009

super_guy

  • 1986 Answers

SOURCE: DOOR PANEL REMOVAL

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

Cary

  • 114 Answers

SOURCE: audi tt 3.2 quattro oil filter change

The insert or cartridge filters are easy to change..You must jack up the front of the car, remove the engine belly pan. in the front of the motor there is a black cylindrical housing for the oil filter cartridge..On the bottom is a cap that just screws off..Unscrew the cap, take it off, slide the old insert off, then slide the new one on..Screw the cap back on and voila! you are finished..If the insert came with a new rubber o-ring, make sure to replace the old one on the cap.

Posted on Sep 18, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you disable seatbelt chime in a 2011 BMW?


You don't. Legal requirement. Like asking how to remove a catalytic converter.

Oct 04, 2014 | 2011 BMW 3 Series

1 Answer

I have a 2002 Chevy Tahoe and the 3 point seatbelt on the rear passenger side rear seat has been pulled out all of the way and now it won't retract back into it's holder. Is there an easy wa


The re-tractor is called an Inertia Reel. There on the side, remove the cover and there is a trigger release on most. If the spring is broken, you will need to replace the reel. Check at a local junk yard for the best price.

dc don

Sep 03, 2012 | 2002 Chevrolet Tahoe

1 Answer

Removing headlights BMW x1


Open your BMW's hood. Locate the black bulb cover for the bulb you need to replace. It is located behind the assembly in the engine compartment.3 Reach down into the compartment and turn the cover to the left to pull it off.4Turn the bulb holder left and pull it out of the assembly.5 Remove the old bulb from the holder. Pull it straight out.6 Insert the replacement bulb into the holder.7 Replace the bulb holder into the assembly and turn it to the right.8Replace the bulb cover and turn it to the right
  • Dec 03, 2011 | 2011 BMW X1

    1 Answer

    Airbag and seatbelt light stay on in 2002 Jeep Grand Cherokee. The lights randomly came on for no reason.


    Just recently, I inadvertently removed the yellow doohickey that holds the 2 x 10 amp fuses in the interior fuse bank of my 2002 WJ Jeep Grand Cherokee Laredo. I checked the fuses and they were ok so I inserted the fuse holder back in.. Low and behold the seatbelt and airbag light came on and stayed on. After several quick fixes etc to get the lights to go out, I finally returned to the fuse holder and discovered that A. You need to squeeze in the tabs to get the fuse holder out and B. the fuse holder when being re-inserted will not automatically clip in... you have to squeeze the tabs again to press the fuse holder fully home. I started the old girl up again and no more lights.

    Jul 20, 2010 | 2004 Jeep Grand Cherokee

    1 Answer

    2004 Chevy Cavalier headrest removal.


    try putting a small screwdriver into the slots around the pole white ring on the bottom of headreat and pulling it out at same time. I would recommend two people doing this.

    Jan 10, 2010 | 2004 Chevrolet Cavalier

    1 Answer

    No power to bmw x5 ns brake light


    Hi , remove the brake light bulb and look at where the bulb contacts the holder , you may find that you have a hole burned into the holder where the contacts have been arking , if this is the case you will need a replacement kight unit , reagards mark

    Jun 27, 2009 | 2004 BMW 5 Series

    1 Answer

    Rear seatbelts jammed down backseats


    hello tracieandmia, I am assuming that the seatbelt buckles are just underneath the seat. The rear seat bottem can be removed for access. If you reach under the front part of the seat bottem near each corner and lift up, the seat will release. You will need to give it a little yank and use a little force for it to release. Once each corner is released you can remove the seat bottem. To install the seat, slide it back under the seat back and push hard down on each front corner that you had previuosly pulled up at. You should hear a definite click/lock sound when the catches are locked.

    Apr 04, 2009 | 2001 BMW 3 Series

    2 Answers

    Broken cup holder in 2000 BMW 740iL


    unfortuantly the whol center councle needs taken apart it is harder than it looks sorry for the bad news, an easy fix is to just replace the front part of the cup holder

    Mar 24, 2009 | 2000 BMW Z8

    Not finding what you are looking for?
    2008 Audi TT Coupe Logo

    Related Topics:

    325 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Audi Experts

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22485 Answers

    Marvin
    Marvin

    Level 3 Expert

    85239 Answers

    Thomas Perkins
    Thomas Perkins

    Level 3 Expert

    14850 Answers

    Are you an Audi Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...