SOURCE: How to change the rear lights on a 2003 Buick Century.
yes you will you will have to take side trims and sill panel off get a 10 mm ready and take the bolts out the tail liaghts should come out the license lamps have screws in them and if you looka t them but you should be able to twist bulbs and pull them out / Please rate my response thank you very much
SOURCE: how do you change the license plate light bulb
OK>>> it is very cold here, but nonetheless..I went outside to check on my Oldsmobile for your benefit....On mine (I can't guarantee it is the same for all of the vehicles listed above). If you are looking at the license plate, LOOK UP and you should see the bulb and whatever encasing is there. Mine is in a tube and it is attached with (2) mini bolts that will need to come out first, then it just looks like a simple matter of disconnecting the electrical plug, taking out the old bulb and putting the new one in. I hope this helps someone....
SOURCE: need to replace license plate bulb on my 2005
1. Open the hatch and stand under it.
2. Remove pull handle from the inside of the hatch (2 screws under pop panels).
3. Starting in the lower corners, gently pry the entire interior panel from the hatch,
and leave it hanging from the wiper area near the glass.
4. Grasp the bulb housing and twist to the left while pressing inward.
5. Replace with a 1156 bulb.
SOURCE: 2000 Buick Lesabre custom liscense plate bulb
kind of tricky, took me an hour to get it figured out, but you got to opend the trunk and take out the 10 or so 10mm nuts sticking out of the backside of the lid, then the whole solid piece where the lights are on the back will slide off, then you can change the bulbs above the license plate and put it all back together
267 views
Usually answered in minutes!
×