Replace a cushion shield On a 2010 chryslertown and Country drivers side

Follow the link for instructions Battery Replacement 2006 2011 Buick Lucerne 2006 Buick Lucerne CXS 4 6L V8

Power Recliner
The driver seat has an electro-mechanical backrest adjuster. The backrest adjustment switch is located on the side of the seat cushion side shield and is part of the seat control switch. The recliner motor is mounted to the backrest frame. Power recliners and motors are only serviceable by installing a new backrest frame assembly.
Does yours have Driver and Passenger Power Seats Without Memory Or Power Driver Seat With Memory ?

B1666 Seat Driver Recline Motor Stalled On-Demand If the motor does not operate, Go To Pinpoint Test L . If motor operates, Go To Pinpoint Test M . Take it an have it check !
Does your

Fuse is under the dash drivers side Accessory fuse in panel
Mike

pull up the front of cushion on either side in turn, put your fingers under the front edge about 10 inches from outer edge you will feel a little plastic lever, you slide to one side, repeat for other side you can then remove seat cushion.

i had this same thing happen to me. this may or may not be your problem. outside at the very bottom of your windshield there should be a grate, that will come off. under that is a ruubber type gasget that sometimes is not in the right position and the water drips inside your car. i had a wind-shield replaced and the tech did not put the rubber gasget back in it's proper place. it was like a 10 min fix and it never leaked again, amazing

You likely have a faulty blend door. It could be electrically, mechanically related, or even a broken door. It may be the blend door motor, or possibly the temp sensor.

One of the heat shields on the exhaust system.

depending on if it is the seat bottom or the seat back as they are seperate systems if both dont work then you probably have a electrical problem with the module or the switch not the heaters them selves, if it is one of the heaters then you must remove the seat cushion and replace it or the seat back cushion the heaters are intergrated into the foam the seat cushion unbolts with two fifteen millimeter nuts just under the front of the seat and unclips from the rear as you pull up and forward the seat back cushion is much more involved and should be done by a pro

Remove the wiper arms (pop off the caps at the base) and the 15mm nut. Take out the screws that hold down the wind shield cowl lift it away to expose the washer hoses. Unplug the wiper motor (center driver's side) by pulling out the red clip on it and squeezing the tab. Remove the 13mm nut from the wiper motor idler arm and take out the 3 10mm bolts that hold it in place. Squeeze it out from under the wiper transmission, or loosen the lower bolts. You'll see them. Not a difficult job, just take your time.

Hope I've helped.

there is a solid state relay located on the frame rail on the drivers side under the air box it has four wires going to it and has most likely failed. there was (or is) a recall on this part and they cost around $40 dollars they are pretty easy to install but make sure to clean the frame rail where the relay bolts down to, and make sure the relay sits flat and has no debris blocking airflow to it as these get very hot and will fail agian if not properly installed -jeff please rate