Dark green snake with light green strip down its back

2001 mazda 626 2.5 v6. Wire harness to my boss factory raido was cut off and cant seem to figure out what goes where...orange.yellow...light green and light grey..pink and brown..purple and white..dark grey with black strip and sold dark grey...red..blue...black..yellow..can anyone help me out

Blue strip Garter Snake

https://www.floridamuseum.ufl.edu/herpetology/fl-snakes/list/thamnophis-sirtalis-similis/

It will be on the back side of the engine (firewall side) in the block down by where the oil pan bolts up. Look towards the passenger side. It will have three wires. Pink with yellow. Brown with light blue. Dark blue with dark green.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Keep things simple and make this much easier. You will need a test light and probe each of the wires and you will have to do each wire while the lights are on, then the brake applied and then the turn signal and you will be in business in short order. Be shure to make all connections secure and use shrink tubing to waterproof the wires.

Not sure I follow your question. The replacement lamp assembly did not come with the wiring for the lights ?
According to the diagram, white lite green is the backup lamp, black dark green is ground, white brown is the parking light, and white dark green is the turn signal or brake light.

Here is the radio wiring.
2008 Dodge Ram 1500 Car Stereo Install Instructions
Car Radio Battery Constant 12v+ Wire: Gray/Red
Car Radio Ground Wire: Black
Left Front Speaker Positive Wire (+): Dark Green/Yellow
Left Front Speaker Negative Wire (-): Dark Green/Light Blue
Right Front Speaker Positive Wire (+): Gray/Yellow
Right Front Speaker Negative Wire (-): Gray/Light Blue
Left Rear Speaker Positive Wire (+): Gray/Light Green
Left Rear Speaker Negative Wire (-): Gray/Dark Green
Right Rear Speaker Positive Wire (+): Dark Green/Gray
Right Rear Speaker Negative Wire (-): Dark Green/Light Green

2010 Dodge Ram 2500 Car Audio Installation Guide



Left Front Speaker Positive Wire (+): Gray/Violet
Left Front Speaker Negative Wire (-): Gray/Yellow
Right Front Speaker Positive Wire (+): Dark Green/Violet
Right Front Speaker Negative Wire (-): Dark Green/Yellow


Left Rear Speaker Positive Wire (+): Gray/Dark Green
Left Rear Speaker Negative Wire (-): Gray/Light Green
Right Rear Speaker Positive Wire (+): Dark Green/Gray
Right Rear Speaker Negative Wire (-): Dark Green/Light Green

There may be extra wires you don't need. The basic set of wires on the radio is 4 pairs of colored wires--one black-striped and one plain for each speaker. Yellow is usually accessory power, red is hot, and black is ground. Some additional wires may be one for a power antenna, one for an external amplifyer, and one for facelight (in case it will run on dimmer)
The car should have the following corresponding wires:
Radio 12v--- orange
Radio Ground--- black
Radio Ignition--- yellow
Radio Illumination--- brown
Dimmer--- gray
Power Antenna--- pink (if you have one)
LF Speaker +/- tan - grey
RF Speaker +/- lt green - dk green
LR Speaker +/- brown - yellow
RR Speaker +/- dk. blue- lt. blue

The car or radio could have additional connectors, such as for a subwoofer, CD changer, etc.

i have a 2003 monte carlo and the wires came out of the plug under the seat. im trying to put them back in so my seat will be able to work. there are 12 wires that make up 6 connections. i need to know what wires go together. the wires are red with blue strip, red with green strip, red with white strip, yellow with blue strip, yellow with green strip, yellow with white strip, light green, green, peach, blue, light blue, and yellow.

Constant 12v + orange
Switched 12v + yellow
Ground Black/white
illumination grey/black
dimmer brown/white
antenna trigger dark green
left front speaker + tan
left front - grey
right front + light green
right front - dark green
left rear + brown
left rear - yellow
right rear + dark blue
right rear - light blue