Question about Ford Taurus
SOURCE: neutral safety switch
most gm nuet safety is yellow and purple .....out of ignition switch is a big yellow wire that is crank out and input to nuet saf switch......out of nuet switch is color purple that goes strieght to start selenoid.....purple wire also goes to the crank fuse 5amp.. in the fuse box under dash... this fuse goes to the pcm main computer.. same for auto and clutch
Posted on Sep 04, 2009
Neutral Safety/Back-up Light Switch
This is a combination switch which controls both Neutral Safety and Back-up lamp circuits.
C6 neutral start switch
Removing the AOD neutral start switch
Removing the Manual Lever Position (MLP) sensor
As of 1994, the neutral safety switch is referred to as a Manual Lever Position Sensor (MLP).
Adjusting the MLP sensor
Park is the last detent when the manual control lever is full forward. Return 2 detents toward the output shaft for Neutral.
I hope help you. Good luck (rated this help).
Posted on Sep 18, 2009
at top area of transmission where the shifter cable attaches to lever and shaft @ base of shaft is gear selector/nuetral safety switch remove nut on end of shaft and usually 3 - 8mm screws holding switch down ,unplug electrical connector,remove lever from shaft and raise switch up and out
Posted on Jul 08, 2010
SOURCE: what wires do I need
The wires on the Transmission Range Sensor that control the ability to crank the starter are the BLACK/GREEN wire at Pin 6 and the wire at Pin 10 which is either BLACK/GREEN or BLACK WHITE depending on your model. (build - date and transmission type)
With all that said, I think it only fair to warn you that bypassing these wires will set codes in your Engine Control Module. It is not going to like it if there is power at pin 10 with the transmission in reverse or any of the forward gears. This may also cause your transmission to not shift properly because the ECM will not know for sure what gear you are in.
Posted on May 10, 2011
Testimonial: "thanks so much for the information I will install a switch and only use it when needed and to ensure that this is my problem."
Tips for a great answer:
Sep 15, 2015 | Cars & Trucks
Feb 04, 2015 | 2003 Ford Taurus
Aug 18, 2014 | 1999 Ford Taurus
Aug 23, 2013 | 2003 Ford Taurus
Aug 08, 2011 | 1996 Ford Taurus
Nov 23, 2017 | 2003 Ford Taurus
Welcome to FIxYa.com
Have the neutral safety switch checked and the connector to it may have come loose if all is well replace switch
Thank you for using FixYa.com
Regards, Lee Davidian
Nov 18, 2010 | 2006 Ford Taurus
Sep 12, 2010 | Cadillac Brougham Cars & Trucks
Sep 17, 2009 | Ford E-250 Cars & Trucks
Dec 08, 2008 | 2003 Ford Taurus
414 people viewed this question
Usually answered in minutes!