Location of acuator spring on a 2002 Dodge Ram truck 2 wheel drive, 3.7 lt. engine.

Mike Butler

• 6674 Answers
• Posted on Dec 22, 2008

SOURCE: belt diagram 2004 5.7 liter engine dodge ram 1500 1/2 ton 4x4

click on this link, and scroll down to 5.7L

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800ba71e

SOURCE: i need the diagram for the drive belt for a 2004

Here is a link to the diagram you need...

http://www.gates.com/common/part_locator/view_diagram.cfm?id=S7035

Please post feedback...thanks

SOURCE: How to replace front wheel bearing on a 2002 Dodge 1500

You take off the right tire. You have take all the bolts out from underneath the

SOURCE: what is the diagram of the firing order for 94 dod...

v6 1-6-5-4-3-2
v8 1-8-4-3-6-5-7-2

ZJ Limited

• 17989 Answers
• Posted on Jul 28, 2011

SOURCE: I need the diagram

Check this diagram and click over image for zoom...

Fig. Belt routing - 3.7L, 4.7L and 5.7L engines

1. Install new belt. Route the belt around all pulleys except the idler pulley.
   
2. Rotate the tensioner arm until it contacts its stop position.
   
3. Route the belt around the idler and slowly let the tensioner rotate into the belt. Make sure the belt is seated onto all pulleys.
   
4. With the drive belt installed, inspect the belt wear indicator. On 4.7L Engines only, the gap between the tang and the housing stop (measurement A) must not exceed 24 mm (.94 inches). If the measurement exceeds this specification replace the serpentine accessory drive belt.