Bad u joint? Wheel bearing? Jack it up off ground and run it in gear while someone else isolates noise source.
SOURCE: 1999 Mitsuishi Montero sport 2H shift light flashing
Bad 4wd position sensor located on transfer case or bad sensor located on right front axle housing for 4wd engagement position.
SOURCE: 1999 mitsubishi montero sport cruise control issue.
possible bad speed sensor, get computer codes
SOURCE: Montero Sport, Automatic transmission fluid change
I definetly highly reccomend you to use Mitsubishi genuine Diamond SPIII Fluid, you'll feel your transmission more powerfull, and will help you to keep it just like new. I've tried with "Import multivehicle" from Castrol but a within 6 months the gears began to slip.
SOURCE: how do you tighten ac compr belt on mit montero sport xls 3.5?
on the engine between the a/c compressor and crank pulley is adjusting pulley its above both of them in the middle loosen the 14mm nut on front of the pulley and turn the 12mm adjusting bolt clockwise until the belt is tight but not too tight if it continues to squeal just replace the belt you do not have to take any other belts off to replace
SOURCE: where is the bank 2 sensor1 located in a xls
what?? bank 2 is the drivers side of the engine sensor 1 is located before the cat conv next to the frame by the trans bell housing very tight location but is possible to change need a o2 socket that looks like a line wrench but beware if its seized you will have to heat with a torch or you will rip the threads out of the pipe/cat
88 views
Usually answered in minutes!
×