Cars & Trucks Logo

Related Topics:

Kurt Redhead Posted on May 05, 2017

Remove alternator from a 2008 nissan sentra - Sentra Nissan Cars & Trucks

5 Related Answers

mike raines

  • 120 Answers
  • Posted on Feb 20, 2009

SOURCE: 2000 nissan sentra alternator removal

take the front mount off the front of the motor jack up or let down futher

Ad

Anonymous

  • 2 Answers
  • Posted on Feb 28, 2009

SOURCE: power steering reservoir for 2008 Nissan Sentra 2.0 S

I had this question initially. However, the Nissan Sentra (starting in 2007) has an electric Power Steering. It DOES NOT need any power steering fluid. The electric power steering is suppose to give you better fuel efficiency and lower maintenance cost.

Anonymous

  • 770 Answers
  • Posted on Jun 21, 2009

SOURCE: brake light, 2008 Nissan Sentra

Open the trunk and locate the trim door that covers the back of the drivers side tail light assembly. Open the door and locate the bulb holder. The bulb holder can be removed from the tail light assembly housing by turning counter clockwise 1/4 turn. Holding the bulb holder in one hand, press gently on the bulb and turn then bulb counter clockwise to remove. Replace with a combo bulb and reverse proceedure to re-install.

A3sthetix

Ahmed Raza

  • 41 Answers
  • Posted on Jun 22, 2009

SOURCE: How do I change brake light bulb of Nissan Sentra 2008

Was able to complete this job successfully:
It's a little tricky to do without pictures, but I don't have any available right now.

  1. Access the trunk
  2. Remove the material covering the light. You'll need to remove the black pegs by lifting the centre part. A flathead screw-driver will help. There are 2 to remove -- one directly behind the brake light and another at the top of the trunk.
  3. Pull back the material to expose the brake light wiring and the metal frame of the car.
  4. There are 2 nuts / screws to remove near the entrance of the trunk. Both are about 4 inches apart and hold the tail light's cover in place. Remove both.
  5. Using a bit of force, you will be able to pull off the entire tail light from the frame of the car. This is done on the exterior of the car.
  6. Rotate the problematic light from it's housing (it should come off with ease) and pull it out of the socket. Brake light and indicator are a 3057K bulb.

Anonymous

  • 1 Answer
  • Posted on Sep 13, 2009

SOURCE: alternator

I am changing the alternator on a 1996 Nissan Sentra, I loosened and unscrewed the bolt, but cannot remove the alternator . Any suggestions?

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

How to remove the spark plugs on a Nissan Sentra

need to remove the ignition coils from the top of engine then remove the spark plugs
2helpful
1answer

I have a 2008 nissan sentra and when I turn the lights the voltage drops

Go to autozone,have them test your battery and alternator,it's free.
0helpful
1answer

Recalls on the 2008 nissan sentra

Recall ID# 72326 - SERVICE BRAKES, HYDRAULIC:FOUNDATION COM
Recall Date: July 11, 2008
Units Affected: 169202


Read more: http://www.automobilemag.com/auto_recalls/11/nissan/sentra/#ixzz2Hy8jQii1
2helpful
1answer

How do i change alternator belt on 1996 nissan sentra

Click on the following free direct Link. It has several Diagrams including the correct Serpentine/Drive Belt Diagram for your 1996 Nissan Sentra 1.6L DOHC In-Line 4-Cylinder. Included are Instructional and Directional Diagrams including how to remove/replace your Alternator Belt and set the proper Tension.

http://www.2carpros.com/car_repair_information/year/1996/make/nissan/model/sentra/1996_nissan_sentra_drive_belt_routing_diagram.htm

Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!



2helpful
2answers

Alternator

1996 Nissan/Datsun Sentra 1.6L SFI DOHC 4cyl

Nissan Sentra/Pulsar/NX 1982-1996 Repair Guide
The alternators for Pulsar and Sentra have not changed much over the years. However, the 1987-88 alternators for Pulsar and Sentra have a different internal diode assembly.
  1. Disconnect the negative battery terminal.
  2. Disconnect the 2 lead wires and connector from the alternator.
  3. Loosen the drive belt adjusting bolt and remove the belt.
  4. Unscrew the alternator attaching bolts and remove the alternator from the vehicle.
To install:
  1. Install the alternator and retaining bolts loosely.
  2. Install the belt and connect the wiring.
  3. Adjust the belt as outlined in . Torque the retaining bolts to 25 ft. lbs. (34 Nm).

I hope help you with this (rated this help).
2helpful
1answer

Brake light, 2008 Nissan Sentra

Open the trunk and locate the trim door that covers the back of the drivers side tail light assembly. Open the door and locate the bulb holder. The bulb holder can be removed from the tail light assembly housing by turning counter clockwise 1/4 turn. Holding the bulb holder in one hand, press gently on the bulb and turn then bulb counter clockwise to remove. Replace with a combo bulb and reverse proceedure to re-install.
10helpful
1answer

Power steering reservoir for 2008 Nissan Sentra 2.0 S

I had this question initially. However, the Nissan Sentra (starting in 2007) has an electric Power Steering. It DOES NOT need any power steering fluid. The electric power steering is suppose to give you better fuel efficiency and lower maintenance cost.
Not finding what you are looking for?

96 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...