SOURCE: 2003 Honda Oddyssey - PO325 Knock Sensor
If The engine in your van is a 3.5L, the knock sensor is under the upper intake manifold. This has to be removed in order to access the sensor on top of the engine block. The job requires an upper intake gasket set and about 1.5 hours to do; if you are handy with tools. For those who aren't; better off leaving this one to the professionals.
SOURCE: where is throttle position sensor located on 2000 honda passport
Normally attached at opposite end of throttle linkage. Remove your air cleaner intake hose at throttle body, and observe throttle plate that opens & closes as you press accelerator, it will be at the end of that, on outside of housing.
SOURCE: Brake Fluid Sensor
I believe it is a float in the master cylinder. If it's on, check your barke fluid level. Add if needed.
The reason for low fluid is that the front disc brakes are wearing down causing the brake caliper to move out which lowers the fluid level in the reservoir. So, also check your front brakes for wear.
God luck.
Please rate as fixya if this solves your issue. Thanks
SOURCE: Knock Sensor installation for 2003 Honda Pilot
I don't know where the knock sensor is exactly on this engine, but if you buy the replacement first it will help you identify it.
It's screwed into the block near the head or the head itself. It has an electrical connector attached to it (two wires, I believe).
The replacement is pretty simple: remove the electrical connector from the old one; screw it out with a wrench; screw the new one in and; plug the connector onto it.
Charlie
SOURCE: location of knock sensor on a 98 honda civic v -tech 4 cylinder
It is on the lower left side of the engine (side towards firewall - see picture).
Knock sensor failures are pretty rare, why are you looking for it?
262 views
Usually answered in minutes!
×