starter relay is in power distribution center near battery. don't know which engine you have, but if you flollow the positive cable on the battery, it will lead you to the starter. Most are not difficult to replace, depends on how much experience you have. One tip...dont overtighten wire connections on starter the solenoid cover is plastic and can break.
SOURCE: How to install the front license plate on the 2008
There should be guide holes in the bumper for you to mount the plate. It's recommended to mount a backing piece and then mount the place onto the backing for sturdiness. If there are no holes, you can just screw two holes into the bumper
SOURCE: location of cabin air filter
It can have a cabin air filter, but most vehicles ship without it.
Either way, you can access the cabin air filter housing by opening the glove box all the way (squeeze the sides so it clears the stops).
The filters are around $15 at the dealer.
Whether or not there's a cabin filter installed, make sure you're also
following Chrysler's recommendations in the owner's manual—running the
air on recirculate all the time will encourage mold and bacteria to
grow.
Good luck
SOURCE: like to know what tipe of antifreeze 2008 jeep
Your Jeep uses a H.O.A.T engine antifreeze that is pink in color. It is not recommended that you mix any other type of antifreeze with the H.O.A.T. Any Chrysler, Dodge or Jeep dealership stocks this type of antifreeze and it is sold already mixed with water. The cost is around $14.00 a gallon.
Do Not Mix any other antifreeze.
SOURCE: how do you reset change
1. Turn the ignition switch to the ON position (Do not
start the engine).
2. Fully depress the accelerator pedal slowly three times
within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure."
Follow these instructions.
2,659 views
Usually answered in minutes!
×