Please Help, Peugeot 206cc roof does not open or close, when closed I press the button to open and I can hear the motor turning, but nothing happens.It is wet by the valve of the back tray.

Various ideas here including a reset. These roofs can be problematic especially as your boot is full of roof, it is unlikely you can get the emergency release! Having the boot lock broken is particularly bad, and at times like this, I bet you wish you had fixed it. My friend has one. An auto locksmith might he able to open the lock.

https://www.google.com/search?q=get+in+the+boot+of+a+Peugeot+206cc+convertible+when+the+roof+is+down

https://www.google.com/search?q=auto+locksmith+near+me

..

Some fixya user told me a website reliablestore it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

Switch or motor bad

In ther back left side is the motor ,check the oil level as they all lose oil over time use hydraulic oil to top up

you still have air in the system

Have you tried to disconnect battery terminal and wait for 5 minutes before connecting again to check the remote locking?

Sounds like the motor is worn out try applying some finger pressure on the sun roof and actuate the closer button and it should close it until you can pull your roof panneling back to expose the motor to be change

To open the boot from the inside is very simple: Pull down the back seat. You will see a dull metal hook on top in the small space between the lock on the boot and the plastic cover of the boot. Push upwards and the door will open. The panel covering the back door is held in with clips and can be easily removed by pulling away from the wipr first and pulling the rest away clip by clip: You will not break anything no matter how hard you pull. To put the panel back on just push the clips back in to place.

there is no manual method. It sounds like a limit switch is not working. Can you hear the motor try to operate? If you push up on the back of the glass a little bit while hitting the switch, what happens.

go here for villager help

http://groups.yahoo.com/group/villagerquest/


The sliding roof panel system consists of the following components:

• RH circuit breaker
• Timer module
• Power window relay
• Roof sliding panel switch (15B691)
• Roof glass panel (50054)
• Sliding roof panel motor (15790)
• Halo moulding
• Roof sliding panel headlining (519A02)
• Roof sliding panel slide links (502M78)
• Roof sliding panel housing (502C22)
• Roof air deflector (500A26)
• Center green diode strip

-------------------------------------
When the roof sliding panel switch is activated, a gear on the sliding roof panel motor drives a spline on the roof sliding panel housing. Within the roof sliding panel housing, the spline is connected to two sliding roof panel cables which cause the roof sliding panel slide links to slide and the roof glass panel to open or to close. The sliding roof panel cables and the spline are part of the roof sliding panel housing. Neither the sliding roof panel motor nor the roof sliding panel housing can be disassembled. If a malfunction is detected with either of these assemblies, the assembly must be replaced.
----------------------------------------------------------------------------
VISUAL INSPECTION CHART Mechanical Electrical

• Damaged sliding roof panel
• Sliding roof panel height adjustment
• Sliding roof panel fore and aft adjustment

• Blown fuse(s):
  • 30A PWR WDW
• Damaged circuit breaker #1
• Damaged wiring harness
• Loose or corroded connections

------------------------

• Sliding Roof Panel Does Not Open or Close

• Fuses.
• Circuit breaker #2.
• Power window relay.
• Sliding roof panel motor.
• Roof sliding panel switch.
• Circuit.

• GO to Pinpoint Test E1 .

• Sliding Roof Panel Will Not Stop in Vent Position

• Sliding roof panel motor.

Switch Removal

1. Disconnect the battery ground cable (14301).
   

1. Gently pry the overhead console from the headliner.
   

1. Disconnect the sliding roof panel electrical connector from the overhead console.
   

1. Disconnect the rear quarter window switch electrical connector from the overhead console, if equipped.
   

1. Disconnect the map lamp electrical connector from the overhead console.
   

1. Remove the overhead console.
   

1. Remove the two roof sliding panel switch screws and the roof sliding panel switch (15B691).
   

--------------------------------------------------------------------------------
Motor Removal

1. Place the roof glass panel (50054) in the closed position.
   

1. Remove the roof headlining (51916). Refer to Section 01-05 for the removal procedure.
   

1. Remove the two sliding roof panel relays from their brackets.
   
   
   
   
   

1. Disconnect the two sliding roof panel motor electrical connectors.
   

1. Remove the two sliding roof panel motor screws and the sliding roof panel motor (15790
   

If you hear the motor then you can almost certainly rule out electrical issues, it souonds more likely that the roof panel or drive mechanism is jammed or stuck, If the roof is closed then push up on the rear of the sunroof and see if it "pops up" a bit then while still pushing up hit the button to open.If it is anywhere in between open and closed try pushing it open or pulling it closed while you are pushing the button,if it moves inspect the tracks and lubricate