SOURCE: Tranny wont shift into fifth gear.
you could retry bleed clutch slave cylinder,should really replace these when replacing clutch if high mileage or it might be fifth gear ring gear broken or worn looking at gearbox strip or new gearbox i would try rebleeding clutch might have small airlock in it.
SOURCE: 1995 crown vic gear problems/gear shift wont lock
if the shifter is loose and sloppy feeling then the shift cable bracket has come loose under the dash at the steering wheel. remove the lower panel under the steering wheel so you can see under the dash then get flash light and look while jiggling the shifter. you should be able to see the cable and bracket. if the bracket is loose then tighten the bolts. note this bracket is at the steering colum.
SOURCE: A4LD 4X4. trans. wont engage into gear
It grinds just sitting still? Will it do it with the transfer case in neutral or 4x4?
SOURCE: 1992 ford tempo blower motor
If you look up behind glove box (it will come out if needed) you should see wires going into heater housing/duct, then out to blower motor. The connector there should be attached to a resistor that may have gone bad. I believe there is 2 small screws holding it in to housing.
SOURCE: 1995 crown vic gear problems/gear shift wont lock
most likely the shift tube bushings are bad- you may have also lost a few screws in the shift tube or they could just be loose. you have to pull the steernig column down to inspect/repair it.
87 views
Usually answered in minutes!
×