Question about 2013 Dodge Avenger

1 Answer

Where is the crankshafts solenoid on a 2013 avenger se 4cylinder ?

Posted by Nelson Negron on


1 Answer

RoadkillJoe Plank

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Director Badge:

    Uploaded 100 video answers.

  • Dodge Master
  • 286 Answers

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My driver side headrest is popped out from the top of the setting. Like I slammed on brakes and it popped out for a restraint. Tried pulling the straps up, but no luck

The best solution you'll get from books at

These are books containing info on repair, service, troubleshooting, parts info, assembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc

Jun 21, 2018 | Dodge Avenger Cars & Trucks

1 Answer

My abs light came on after I change my wheel bearing on my 2008 Dodge Avenger SXT 4cylinder

check the wiring connections and the sensor is properly installed
if there is no problems with the sensor , the light should go out after the system resets

Apr 05, 2017 | Dodge Cars & Trucks

1 Answer

How to reset the check engine light on 2013 dodge avenger without a obd2

if theres used to work with older trucks not sure now , you can disconnect the truck battery for 24 hrs before you reconnect the battery.

Jun 19, 2015 | 2013 Dodge Avenger

1 Answer

How to reset the check engine light on 2013 dodge avenger

Use scan tool to erase codes, or have parts store do this.

Jun 19, 2015 | 2013 Dodge Avenger

1 Answer

Where is the crankshaft position sensor located on a 2010 dodge avenger 2.4L

most are located on the ft lower part of engine by crankshaft with 2 wires going to it

Oct 17, 2014 | 2010 Dodge Avenger

1 Answer

PO017 code on a dodge journey 2009

P0017 Dodge - Crankshaft-Camshaft Timing Misalignment Bank 1 Sensor 2Possible causes - Engine oil dirty
- Incorrect engine viscosity
- Crankshaft position sensor circuit is open or shorted
- Camshaft position sensor circuit is open or shorted
- Faulty crankshaft position sensor
- Faulty camshaft position sensor
- Timing gear misalign

Nov 13, 2013 | 2010 Dodge Journey SE

1 Answer

I need a diagram for a 2008 dodge avenger drive belt 2.4L 4cylinder

the belt routing should be under the hood or on the upper rad support.some of these are on the timing cover in the form of a placard.if it is missing then draw the routing of the belt before you remove it making sure you draw all the pullys and how the belt goes around them.or you can get the routing from the parts store you bought the belt from.or the library has books that will show it for your car and motor

Mar 24, 2011 | 2008 Dodge Avenger

Not finding what you are looking for?
2013 Dodge Avenger Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers


Level 3 Expert

4372 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides