Question about 2008 Audi A6

Open Question

Blower motor resistor location Audi A6 2008 - 2008 Audi A6

Posted by Phillip Grasso on

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My audi a4 only blow heat on when it is running on high speed


You have a defective HVAC blower motor speed control resistor, replace it. When they go bad they only allow the blower to work on high speed. The resistor is located near the blower motor.

Nov 24, 2016 | Audi Cars & Trucks

1 Answer

LOCATE AC RESISTOR RELAY


usually on the firewall close to the blower motor .

Aug 29, 2015 | 2005 Audi A8 L

1 Answer

Need to locate the motor blower resistor for my 1999 mercury mountaineer, it has dual air, the resistor for the back is fine but the one in the front is bad and i cannot locate it. Please help.


If you have a manual system, you have a resistor. If electronic, you have a blower motor speed controller. Please rate if this helps.

here is info:

Control System Outputs-Manual A/C
Blower Motor Switch Resistor
The heater blower motor switch resistor has the following features:
  • The assembly is located on the evaporator housing in the engine compartment.
  • Three resistance elements are mounted on the resistor board to provide four blower motor speeds.
  • Depending on the heater blower motor switch position, series resistance is added or bypassed in the blower motor circuit to decrease or increase blower motor speed.
  • An overheating protective device (thermal limiter) will open the resistor coil circuit when the temperature reaches 121°C (250°F) interrupting the blower motor operation in all speeds except HI.
  • The thermal limiter cannot be reset and is not serviceable.
Control System Outputs-EATC
Blower Motor Speed Control
The blower speed control is located on the evaporator housing in the engine compartment.
  • The function of the blower motor speed control is to convert low power signals from the electronic automatic temperature control module to a high current, variable ground feed for the blower motor (18527).
  • The blower motor speed is infinitely variable and is controlled by the electronic automatic temperature control module software.
  • A delay function provides a gradual increase or decrease in blower motor speed under all conditions.

Jan 10, 2011 | 1999 Mercury Mountaineer

2 Answers

I need to locate my blower motor resistor on my 1999 S-10. do u know where it is located on my s-10?


The resistor is located under the hood on the passenger side. At the back of the engine compartment you need to locate the airbox it can be identified by a circular piece that's right beside the fender on the firewall (this is your blower motor) to the right if it (looking from the front of the truck) about 4 -6" you will see a wire plug. Unplug this connector and locate the four screws that attach it to the air box. Remove these screws and pull the resistor from the housing.

Hope helps (remember to rate this answer).

Dec 13, 2010 | Chevrolet S 10 Cars & Trucks

3 Answers

Blower motor resistor, where is it located/


It will be up under the dash on the passenger side near the blower motor. It will have 5 or six wires in its connector

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Nov 10, 2010 | 2000 Jeep Grand Cherokee

1 Answer

Blowers not working on audi a4 avant 96


it is the variable resistor blown replace it.It is located to the blower motor behind the glove box

Nov 22, 2009 | 1997 Audi A4

1 Answer

2005 Kia Sorento only blows hot and cold air on high. Is it a blower motor resistor and if it is where is it located?


If the blower moter only works on hi speed it is the blower motor resistor that is bad. The blower motor resistor is located under the passenger side of the dash next to the blower motor. It is not necessary to remove the blower motor to change the resistor.

May 12, 2009 | 2005 Kia Sorento

1 Answer

Blower motor fuse is located 99 mercury cougar


SECTION 412-04: Control Components 1999 Cougar Workshop Manual REMOVAL AND INSTALLATION Blower Motor Resistor Removal
  1. Remove the upper footwell trim panel (passenger side).
    • Remove the pushpins.
  1. Disconnect the blower motor resistor electrical connector.
  1. Remove the blower motor resistor.
-------------------------------------------------------------------------
f9d16f6.gif

May 06, 2009 | 1999 Mercury Cougar

1 Answer

Where is the heater blower motor resistor located


if you locate the blower motor the rester is the wire that atachec to blower motor fallow wire till you find a circuit bord this is ur resistor

Dec 06, 2008 | 1999 Mercury Villager

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

371 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14846 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...