Good Day I have a 1988 nissan sentra with the e16i engine. Would like to know the location of the cluster gauge temperature sensor as the temperature isn't working, thanks!

It can be the water temperature sensor. Sensors generally increase in resistance causing less current flow through the circuit which in turn causes less needle deflection on your temperature gauge. I have a 93 Mazda B2200 doing just that.

The Pulsar starter is located centrally, underneath the engine close to the passenger compartment."According to my car, the E16i engine, it is on the drivers side of the engine below/behind the distributor.

Performance chips of BMW.

faulty sensor or a damaged wire to the sensor

the wire going to the temperature sensor is dis connected, or not functioning, .. on the instrument cluster the temperature gauge is also damaged the arm is stock up. Try to connect the wire to the body ground if you see the arm on gauge goes up the problem is the temperature sensor.

Possibly the intake air temperature sensor or the engine coolant temp sensor are stuck at full hot. The computer will schedule too little fuel--especially with the engine cold and you'll have very little power until the engine actually gets closer in temp to the stuck sensor. The engine coolant temp sensor sends signals to the computer NOT to your temperature gauge on the instrument panel. That is a different sender. So your coolant temp gauge on the instrument panel may show normal.

emissionwiz is wrong.
there is a voltage LIMITER located behind you gauge cluster.
Small silver box usually 4 numbers stamped on back with three wires out of it, yellow, blue, black.

Yes. Have autozone tell you what the code means and go from there. Could be a problem with your water pump spracket or engine temperature coolant sensor or something else.

good day Sir, try this link i hope this will help

nissan sentra2002

if you can not find the link your bestbet is to go to a junk yard and pick up the wiering harnesfor the fan. bring a tester that will give you a digatol read out tester with you. thear is no garente that the first one thay give you will worke. this whay you will know before you pay for it.

You have a burned out bulb. Remove cluster assy and replace bulb. Re-assemble cluster.Re-install cluster.