Question about 1998 Mitsubishi Mirage

Open Question

98 MITSUBISHI Mirage de ,1.5L 4 cyl. motor ...The blinkers don't work, only left blinker working, but had to pull fuse to stop it ? do i have a flasher or a switch gone bad ? PLEASE HELP...

I thought it was afuse ,cause it did'nt have one in the box, so i put one in and the left side started blinking, the switch does nothing at the steering collume.

Posted by christina neal on

Ad

5 Related Answers

bunnydawg

Roberta Smith

  • 5158 Answers

SOURCE: 97 Mitsubichi Mirage blinker will not stop clicking

switch needs to be replaced on the steering column

Posted on Mar 18, 2009

Ad
MNfisherman

Nate Stansfield

  • 11896 Answers

SOURCE: My blinkers wont work but the hazards work. No fuses burnt out.

That would most likely be the switch itself. Fairly common

Posted on Aug 28, 2009

Ad

John Donahue

  • 593 Answers

SOURCE: where is the cig lighter fuse located

The lighter fuse is located in the junction box under the dash on the left
side, above the kick panel. Fuse #7 15amp. Hope this helps.

Posted on Mar 21, 2010

Testimonial: "dead on answer, thanks a bunch"

richochet

  • 1026 Answers

SOURCE: the left blinker is stuck ON

your switch is faulty

Posted on Apr 05, 2010

Jeremy Langston

  • 37 Answers

SOURCE: right blinker works, but left one doesn't work at

either check for voltage at the blinker and also check for left blinker fuse . NO voltage at connector there is an open in wire replace try to find the open torn insulator or wire being exposed.

Posted on Jul 02, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blinkers work tail lights work but no brake light. Mitsubishi mirage 2001


check fuses firs, then check the bulbs . If they are all fine check the brake light switch at the top of the brake pedal in the driver's footwell

Jul 04, 2015 | Mitsubishi Cars & Trucks

1 Answer

Windshield wipers don't work. Not the fuse. Also my blinkers don't work. Had to take out fuse. If let in driver side blinker stays on. Arm does not do anything


Hi,

Start with the easy stuff. Since you've already ruled out fuses, both issues sound like bad relays. The blinker relay is usually in the fuse panel and cheap to replace.

The wiper relay if I'm not mistaken is in the switch assembly on the steering column. This is a little more expensive because you have to replace the whole switch assembly.

Good luck!

Mar 09, 2011 | 1998 Mitsubishi Mirage

1 Answer

Blinkers dont work on my 1989 mitsubishi mirage but hazards do?


Turn signals are operated by a different fuse then the hazard flasher - start by checking the fuses - if they are okay you may have a seperate flasher unit for the turn signals too - you may need to replace the flasher unit - hope this helps - good luck :O)

Feb 21, 2011 | 1989 Mitsubishi Mirage

1 Answer

Right blinker works, but left one doesn't work at


either check for voltage at the blinker and also check for left blinker fuse . NO voltage at connector there is an open in wire replace try to find the open torn insulator or wire being exposed.

Jul 02, 2010 | 1997 Mitsubishi Eclipse

1 Answer

98 expedition trailer brake and blinker lights stopped working


check you bulb and there sockets its possible that you burned out one of the two

Aug 20, 2009 | 1998 Ford Expedition

1 Answer

98 nissan altima front left blinker does not work when headlights are on, works when headlights are off but blinks rapidly ,left rear blinker works when headlights are on or off but blinks rapidly also


the rapid blink is because there is a bulb outage some where, Pull Over turn on left Blinker Get out of your car look at the front left blinker hen walk to the rear of your car and look at the left rear Blinker light then do the same for the right side blinkers if all are working rapidly your left right switch is bad

Jul 09, 2009 | Nissan Altima Cars & Trucks

1 Answer

Blinkers and Hazard lights don't work


inside the car where the air conditioning controls and clock is, pull that panel off. there are two plugs on the other side of it. one plug (the white one) is for the clock. unplugging this resets your clock to 1:00. the other one( green) plugs into the hazard button. if this in not plugged in fully, the blinkers nor hazards will work. make sure this is fully plugged in first

Apr 05, 2009 | 1997 Mitsubishi Mirage

1 Answer

97 Mitsubichi Mirage blinker will not stop clicking


switch needs to be replaced on the steering column

Mar 18, 2009 | 1997 Mitsubishi Mirage

1 Answer

I need replace the blinker flasher


The turn signal and hazard flasher unit on this car is located in the interior fuse panel-located under the driver's left side knee protector. they are replaced by simply pulling them straight out. Make sure the prongs are properly matched up when installing the new unit.

Jan 25, 2009 | 2000 Mitsubishi Mirage

Not finding what you are looking for?
1998 Mitsubishi Mirage Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Vincent G
Vincent G

Level 3 Expert

2363 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...