I have a Rytec turbo slide door. It has given me a code of "motor stalled". It still works with manual open and close. How can I erase any codes in the memory ?

SOURCE: the power sliding passenger door will not open even manually

I think I found out what it is. thankyou for all your help

SOURCE: My 2005 Town and Country's right sliding door quit

i just fixed one. it had a broken wire in the harness that moves with the slider, you have to completly pull the harness apart to find it

SOURCE: 2002 Old Silhouette Driver Power Sliding Door will not open

Look in your owners manual there is a procedure to reset the door controls. If that dosen't work maybe the motor is burnt out, it's in the left rear access panel.

SOURCE: Passenger sliding door motor won't close door all the way.

I just fixed my 2005 T&C sliding door. The wire in the plastic rolling chain is broken when resides right under the step pad. It took me 30 minutes to fix.

Go to this link.
http://wiki.answers.com/Q/How_do_you_replace_the_power_sliding_door_wiring_harness_on_a_2005_Town_and_Country_chrysler

Good luck!

SOURCE: the sliding door on my 2004 toyota sienna won't close

Try this.....Find the latch on the door, stick your finger in the hole, lift up and pull the door handle at the same time, the inside latch mechanism should go up, then try the door again. It would be nice if that's all it was huh? Sometimes they stick when they get too cold. If this works for you....spray it with some WD-40 or graphite. Hope this worked for you. Cheaper than the 2000.00 motor!

Bryon