SOURCE: 2004 Nissan Murano How do you clear maintenance light after oil change?
press maintanence button until you see engine oil, then hold trip/reset button... :)
SOURCE: 2004 Nissan Murano, back door can't open
I had a similar problem with a sienna and sometimes the cable ( inside the door) between the handle and the latch gets stuck in the sleeve. Kind of like the brake cable on a bike.
take the panel off by removing all the screws you can see on the panel and pull the panel off. There will be plastic pins holding it. Some of them may pop off and some will break off.
Drip oil down the sleeve so the cable slides freely. I used bike chain oil. Do not use WD40. This is **** and will not work for very long. Try the handles a few times before you put the panel back.
SOURCE: Replacing front struts, 2003 Nissan Murano, how much?
that a hard one to answer. its depends on were you take it. prises very from state to state.like were i work hr labbor rate is 55.00 hr thats in maine . ill say if you take it to a dealer you may pay $300.00 to $400.00 in part and labor.a louco garge would proubly charge $150.00 to $250.00 .but byeing parts for nissan can cost a lot. ask people around you for a good mec. ok have a good day
SOURCE: 2003 Nissan Murano Driver door won't lock or unlock with keyfob
The key fob is the remote. But the remote type that works like a key. The remotes that you just need to carry on you to start the car or truck. That is a Key Fob.
Thanks Jay!
SOURCE: 2003 nissan murano with check engine light codes
P0420 is Catalyst System Efficiency Below Threshold - Bank 1
and
P0456 is EVAP Control System Very Small Leak (Negative Pressure Check)
102 views
Usually answered in minutes!
×